Maytag Range / Cooktop / Oven Hinge Parts

This oven door hinge restores smooth, controlled door movement and a proper seal. Worn hinges can cause a sagging door, poor closure, or binding—replacing the hinge helps maintain safe operation and consistent cooking performance.

• Supports the oven door with a spring mechanism for controlled opening and closing
• Helps pull the door tight against the gasket for an effective seal when closed
• Works with the opposite hinge to keep the door aligned and stable
• Common symptoms include door not closing fully, sagging or dropping, hard-to-open/close action, or heat escaping around the door

• Disconnect power and allow the oven to cool completely before servicing
• Remove the door following your model's instructions; engage hinge locks or use retaining pins if provided
• Replace the hinge in the same orientation; ensure hinge arms are fully seated in the receivers
• Reinstall the door and verify smooth motion and a complete seal

This oven door hinge restores smooth, controlled movement so the door opens easily and closes fully for a reliable seal. Replacing a worn hinge helps reduce heat loss and supports consistent cooking performance and safe operation.

• Provides the pivot and spring-assisted action for opening and closing the oven door
• Helps pull the door closed and hold it at intended stop positions
• Maintains even gasket contact to keep heat inside the cavity
• Common symptoms of a failing hinge: door won't close fully or sit flush, drops or slams open, binds or pops when moving, or shows an uneven gap

• Disconnect power and allow the oven to cool completely before servicing
• Support the door; open to the removal position and release hinge locks, then lift the door off
• Use caution—hinge springs are under tension; wear hand and eye protection
• Install in the same orientation and verify door alignment and smooth operation after reassembly

This door hinge secures and guides a refrigerator or freezer door for smooth opening and reliable alignment, restoring proper door fit and seal. It's a direct-fit replacement designed to match the OEM mounting points. What it does

• Supports the door weight and keeps the door aligned to ensure a tight seal
• Guides hinge motion for smooth opening and closing
• Helps prevent sagging or misalignment that can cause cooling issues or uneven wear
• Works with the cabinet's existing hinge pins and mounting hardware when installed correctly

• One door hinge

• Remove power or unplug the appliance before beginning work to avoid injury
• Support the door during removal and installation to prevent damage or dropping
• Use the existing mounting screws and hinge pins unless replacements are specified