Mtd Chipper Shredder Parts

Throttle spring for lawn mower and chipper-shredder engines. Replaces broken, stretched, or missing springs that connect throttle linkage components.

Secures hoses to the carburetor on outdoor power equipment engines. Replace if clamp is rusted, broken, or missing to prevent fuel or air leaks.

Carburetor gasket creates an airtight seal between carburetor and engine. Replace when worn, cracked, or if experiencing fuel leaks or starting issues.

This is a genuine OEM clamp sourced directly from the manufacturer. It is used in various lawn and garden machines to connect hoses to fittings. It is used to connect piping to water pumps, exhaust pipes to exhaust manifolds, and other similar applications. This connection prevents fluids or air from leaking from the hose. Clamps may be spring or screw/band clamps. Spring clamps require no tools to install and remove; however, the size must be more accurate than when using screw/band clamps. Screw/band clamps are adjustable and can be tightened or loosened. Screw clamps should be inspected periodically to ensure tightness and that the clamps have not rusted.Hose clamps are installed approximately 1/4 inch below the end of the hose. If two clamps are used, there should be 1/4 inch between the two bands. When using a screw clamp, loosen the screw with a screwdriver just enough to fit the clamp over the hose. If using a spring clamp, squeeze the clamp and hold it open. Slide the clamp over the hose and then attach the hose and clamp to the fitting. Slide the clamp into place at the joint and tighten. Do not overtighten. This brass-colored clamp is a spring clamp made of metal; it is sold as an individual unit. This clamp is compatible with many different types of pipes made by various manufacturers.

Exhaust piping connects to the muffler system on small engines. Replace if cracked, corroded, or damaged to restore proper exhaust routing and function.

Replace your worn, broken, or missing throttle linkage spring. This small spring connects to the carburetor linkage on mowers, tillers, and engines.

Threaded stud secures carburetor to intake manifold on lawn mower and outdoor power equipment engines. Replace if stripped, corroded, or missing.

Drive pulley half for snow blowers and snow throwers. Installs on the drive system. Replace if worn, cracked, or damaged to restore proper function.

Tow bar hitch for chipper shredders. Attaches to equipment frame for safe transport behind vehicles. Replace if cracked, bent, or missing hardware.

Tow bar base for chipper shredders. Mounts to the unit frame to support the towing handle assembly. Replace if cracked, bent, or broken.

Secures engine components and mounts on outdoor power equipment. Replace if bolt is stripped, damaged, or missing to ensure proper assembly and fit.

This is an M6 x 35mm bolt used in lawn mower assemblies. It serves as a fastener for securing various components such as brake assemblies and other mechanical parts. Replace this bolt if it is stripped, corroded, sheared off, or missing during a repair.