Mtd Lawn Mower Parts

External gasket kit seals carburetor and engine surfaces on lawn equipment. Replace when you notice fuel leaks or loss of compression. Verify fit with your model.

Replace your lawn mower's air filter to maintain engine performance and fuel efficiency. Dirty filters reduce power and increase consumption.

Air cleaner housing assembly for walk-behind lawn mowers. Replace if cracked, damaged, or no longer sealing properly to protect engine performance.

This recoil starter assembly includes the pull rope, handle, spring, and pulley mechanism used to manually start a lawn mower engine. It mounts on top of the engine and engages the crankshaft when the rope is pulled. Replace this assembly if the pull cord is frayed or broken, the spring no longer retracts the rope, or the starter fails to engage the engine when pulled.

Ignition coil for small engines on lawn and garden equipment. Replace if cracked, damaged, or worn. Includes spark plug boot and wire assembly.

Protects your mower's air filter from dirt and debris. Replace if cracked, damaged, or no longer securely holding the filter. Confirm fit with your model number.

Snowblower won't start or pulls hard? This recoil starter assembly restores reliable pull-start function. Common repair for worn or broken recoil.

Engine racing or won't maintain steady speed? This governor spring controls engine RPM on walk-behind mowers. Simple DIY fix in under 30 minutes.

Throttle linkage spring for lawn mowers and tillers. Connects throttle controls to the engine carburetor. Replace if stretched, broken, or missing.

Seals and insulates the carburetor from engine heat on lawn mowers and outdoor power equipment. Replace if cracked, worn, or causing air leaks.

Heat-blocking spacer that sits between the carburetor and engine block on outdoor power equipment. Replace if cracked, warped, or missing gasket.

Plastic primer bulb that draws fuel into the carburetor when pressed. Replace if cracked, broken, or no longer creating proper seal for priming.

This small tension spring connects to the governor arm on the engine, helping regulate engine speed under varying load conditions. It ensures the throttle responds properly to maintain consistent RPMs. Replace this spring if your engine surges, runs erratically, or fails to maintain a steady speed during operation.

This fuel cap is a genuine Husqvarna part, sold individually. This fuel cap can be used as a replacement part for a lawn tractor. This fuel cap provides covering for the fuel tank and fuel line of the lawn tractor so that debris cannot enter through the fuel line and damage the engine.The fuel cap might have to be replaced at some point within the standard lifespan of the appliance if it cannot serve its function of protecting the engine from damage. This could occur if the fuel cap goes missing or if it is damaged in the form of punctures, tears, rips, scrapes, or erosion so that external materials can pass directly through the cap and into the fuel line. If this is the case, the component should be removed and replaced with this genuine OEM replacement part. Remember to wear work gloves as a safety precaution while repairing or replacing parts within an outdoor appliance. This is an OEM part sourced directly from the manufacturer. It is sold individually. This fuel cap is compatible with the following outdoor appliance brands: MTD, Cub Cadet, Yard Man, and Craftsman.

Fuel cap for gas-powered engines and outdoor power equipment. Seals fuel tank to prevent debris, dirt, and air contamination. Replace if cracked or loose.

Carburetor assembly for snow throwers. Mounts to the engine block to mix air and fuel. Replace if cracked, leaking, or worn to restore proper operation.