Parts for Whirlpool W5CE3625AB00: 02 - Optional Parts (Not Included) Parts

This replacement wire harness connects multiple electrical components to restore reliable electrical connections and signal paths. Use it when factory wiring is damaged, corroded, or causing intermittent power or component failures. What it does:

• Provides the factory routing and connectors to link controls, motors, sensors, or switches.
• Restores consistent power and signal flow to affected appliance circuits.
• Helps stop intermittent operation, loss of function, or no-power symptoms caused by damaged wiring.
• Replaces frayed, melted, or corroded wiring that can cause poor connections or arcing.

• Disconnect all power (unplug or shut off breaker) before starting any repair.
• Compare the new harness to the old one for connector types, lengths, and terminal orientation before installing.
• Route and secure the harness per the original clips and channels to avoid heat or pinch points.

This switch seal is a small rubber gasket that protects a control or door switch from moisture and debris, helping maintain reliable operation and prevent damage to the switch assembly. What it does:

• Creates a moisture- and dust-resistant barrier around a switch to reduce shorting and corrosion
• Helps keep switches operating smoothly by blocking contaminants that cause sticking or intermittent contacts
• Supports safe electrical performance by keeping water away from switch terminals and housings
• Common symptom linkage: switch malfunction, intermittent control, or moisture-related failures near switch area

• Disconnect power to the appliance before inspecting or replacing the seal
• Remove surrounding trim or components carefully to avoid damaging the switch or housing
• Confirm correct orientation and full seating of the seal during reassembly for an effective barrier
• If the switch shows damage or corrosion, replace the switch assembly as well

Razor blade scraper.

Size: 10 fl. oz. Used on glass, ceramic and porcelain cooktops.