Parts for Dacor ER36GSCHLP: Outer Assembly Parts

This is a right-side service panel that restores the cabinet enclosure and protects internal refrigerator components from dust and damage. It returns a finished appearance and helps stop drafts or rubbing noises. What it does:

• Covers and protects internal components on the refrigerator's right side
• Restores cabinet alignment and exterior appearance after repair or damage
• Helps prevent dust, moisture, and air leaks that can affect performance
• Reduces rattling or contact noises caused by missing or damaged panels

• Disconnect power before beginning any service
• Remove exterior trim or adjacent panels as needed; keep all fasteners for reassembly
• Handle edges carefully to avoid cuts or finish damage; use gloves
• Follow the manufacturer service manual for panel removal and reinstallation steps

This left-side service panel replaces a damaged or missing cabinet side to protect internal components and restore the refrigerator's exterior fit. It helps keep wiring and insulation covered while maintaining proper airflow around the cabinet. What it does

• Covers and protects internal components located on the refrigerator's left side.
• Restores a flush cabinet appearance and helps prevent accidental contact with wiring or sharp edges.
• Helps maintain proper airflow pathways by closing the cabinet side.
• Addresses issues like exposed insulation, rattling from a loose/missing panel, or visible cabinet damage.

• Disconnect power and empty nearby contents before starting work.
• Remove fasteners holding the old side panel and lift panel off carefully to avoid contact with sharp edges.
• Align replacement panel and secure with existing or manufacturer-specified fasteners; replace any damaged clips or screws as needed.

A replacement service screw used to secure appliance panels and components. Durable fastener sized for common service points, making repairs and panel reassembly quick and reliable. What it does:

• Secures trim, access panels, brackets or small components during service and reassembly
• Commonly used where a shallow truss/wafer head is needed to sit flush without catching
• Helps stop rattling or loose parts caused by missing or stripped screws
• Matches OEM fit for compatible assemblies when the OEM part number is required

• One service screw (#8 x 1/2" truss/wafer head) as specified by the OEM part number

• Use the matching size driver to avoid cam-out and head damage
• Hand-start fasteners to avoid cross-threading; tighten until snug — do not overtighten
• Wear safety glasses and disconnect power before working on electrical appliances
• If a screw threads into plastic or thin sheet metal, consider replacing with the same OEM screw to preserve original threads

Factory wafer-head Phillips screw (#8 x 3/8 in) secures panels, brackets, and covers. Replace missing, stripped, or damaged screws for proper alignment.