Parts for Viking Range VGSS36: Oven Doors Parts

This 1/2" x 1/4" rubber bumper cushions contact points to reduce noise and prevent damage on appliance doors, drawers, and panels. It restores proper cushioning for smoother, quieter operation and helps maintain a snug fit. What it does:

• Absorbs shock where panels or doors meet to reduce rattling and clapping noises
• Prevents metal-to-metal contact that can cause chipping, scratching, or wear
• Helps doors and drawers close more evenly by restoring original spacing
• Commonly used where small, press-fit bumpers have worn, flattened, or fallen off

• One 1/2" x 1/4" rubber bumper

• Press-fit replacement; remove old bumper and press new bumper into the same hole until flush
• No special tools required; use a flat pick or small screwdriver to remove old bumper if needed
• Avoid installing on hot surfaces or near heating elements; let appliance cool before service
• Replace matching bumpers in the same area if others show wear for even performance

Tempered glass panel for gas range oven doors. Replaces cracked, chipped, or shattered glass to restore clear viewing and safe operation of the door.

J-mold trim piece for gas ranges and wall ovens. Installs along edges to cover gaps and provide finished appearance. Replace if cracked or missing.

Replace a faded, scratched, or missing 6-inch black logo badge on your range or refrigerator front panel to restore the original branded appearance.

41-inch stainless steel flexible gas line for gas ranges. Replace if damaged, kinked, or during installation. Verify length and fitting size match your model.

70-inch stainless steel flexible gas supply tubing for gas ranges. Connects your range to the gas line. Replace if kinked, cracked, or damaged.

This is the wire assembly that connects the spark module to the rear burner ignitor on a gas range. It carries the electrical pulse needed to create a spark that ignites the gas at the burner. Replace this wire if the rear burner clicks but does not light, produces no spark at all, or if the wire insulation is damaged or burned.

This wire connects the spark module to the grill or griddle burner ignitor on a gas range. It carries the electrical spark signal needed to ignite the burner. Replace this wire if your grill or griddle burner clicks but won't ignite, or if you notice intermittent ignition failure due to a damaged or corroded wire.

This heat-resistant padding insulates the oven cavity to improve energy efficiency and protect surrounding components from excessive heat. Replace it if you notice heat escaping from the oven exterior, increased cooking times, or if the insulation appears compressed or damaged.