Bosch Refrigerator B30IR900SP Parts

This foam piece is an insulation/cushioning component that protects nearby parts and reduces vibration and noise. It helps keep panels and components from rubbing or contacting each other during operation. What it does

• Cushions components to prevent metal-on-metal contact and wear
• Dampens vibration and can reduce rattling noises
• Separates and protects wires, hoses, or panels from abrasion
• Maintains spacing/isolation where factory foam was installed

• One foam piece

• Disconnect power to the appliance before starting any service
• Remove panels or access covers as needed to reach the foam location
• Fit the foam in the original position and orientation; trim only if explicitly required by the OEM

Wire basket organizes frozen foods inside your freezer compartment. Replace if basket is cracked, bent, rusted, or missing to restore storage space.

Secure your side-by-side refrigerator in the cabinet with this mounting bracket set. Replaces damaged, missing, or worn installation hardware brackets.

This is a fixture component that secures or supports the piston pin mechanism inside a freezer, typically related to the door hinge or lid assembly. It helps ensure smooth door operation and proper alignment. Replace this fixture if your freezer door is sagging, not closing properly, or if the original fixture is cracked or missing.

Interior light fixture for refrigerators and freezers. Replaces broken, cracked, or missing fixtures. Mounts inside compartment to hold bulb.

This inverter is the motor drive circuit that controls variable motor speed for precise operation and energy-efficient performance. It replaces a failed inverter to restore consistent motor control and normal appliance function. What it does:

• Converts and regulates power to the appliance motor for variable-speed control.
• Restores proper motor start/stop and speed changes when the inverter has failed.
• Commonly associated with symptoms like no motor operation, intermittent runs, error codes related to motor/inverter, or loss of specific cycles.
• Helps eliminate erratic motor behavior caused by damaged or malfunctioning drive electronics.

• Disconnect power to the appliance before servicing to avoid shock or equipment damage.
• Handle the inverter carefully and avoid contact with circuit components; observe ESD (electrostatic discharge) precautions.
• Verify connector orientation and secure mounting; do not force connectors or damage wiring.

Fix excessive vibration or loose internal components with this mounting retainer fixture. Secures parts in place to restore stable operation in your appliance.

A lower kickplate-style base panel that covers and protects the appliance's bottom front, restoring appearance and preventing debris from entering the base. Replaces a dented, corroded, or loose lower front panel for a finished look. What it does

• Covers the appliance base to protect internal components from dust, spills, and debris.
• Restores a flush, finished front where the original panel is bent, rusty, or cracked.
• Helps reduce drafts and keeps floor-level access areas sealed.
• Improves appearance when the original panel is scratched, dented, or discolored.

• One base panel (lower kickplate) as stated.

• Disconnect power to the appliance before beginning work; follow all electrical and gas safety procedures if applicable.
• Installation typically requires removing the existing kickplate and fastening the new panel with the original screws or clips; keep fasteners organized.
• Use care to avoid scratching the new panel; lift into place and align before tightening.