Bosch Refrigerator B30IR900SP Parts

This foam piece is an insulation/cushioning component that protects nearby parts and reduces vibration and noise. It helps keep panels and components from rubbing or contacting each other during operation. What it does

• Cushions components to prevent metal-on-metal contact and wear
• Dampens vibration and can reduce rattling noises
• Separates and protects wires, hoses, or panels from abrasion
• Maintains spacing/isolation where factory foam was installed

• One foam piece

• Disconnect power to the appliance before starting any service
• Remove panels or access covers as needed to reach the foam location
• Fit the foam in the original position and orientation; trim only if explicitly required by the OEM

Wire basket organizes frozen foods inside your freezer compartment. Replace if basket is cracked, bent, rusted, or missing to restore storage space.

Secure your side-by-side refrigerator in the cabinet with this mounting bracket set. Replaces damaged, missing, or worn installation hardware brackets.

Interior light fixture for refrigerators and freezers. Replaces broken, cracked, or missing fixtures. Mounts inside compartment to hold bulb.

This left hinge cover is a direct-fit replacement trim piece that protects and conceals the refrigerator door hinge assembly for a clean, finished appearance. Restores protection from dirt and reduces snagging on the hinge area. What it does:

• Covers and protects the left door hinge assembly from dust, debris, and accidental contact
• Keeps the hinge area looking finished and prevents clothing or items from catching
• Common fix for cracked, broken, or missing hinge trim that exposes the hinge hardware
• Matches OEM fit and function to maintain proper clearance around the hinge

• Disconnect power to the appliance and remove any items from the door before starting
• Support the door while removing or installing hinge trim to avoid hinge stress or component damage
• Typically fastens with clips or small screws; use appropriate tools and do not overtighten

A lower kickplate-style base panel that covers and protects the appliance's bottom front, restoring appearance and preventing debris from entering the base. Replaces a dented, corroded, or loose lower front panel for a finished look. What it does

• Covers the appliance base to protect internal components from dust, spills, and debris.
• Restores a flush, finished front where the original panel is bent, rusty, or cracked.
• Helps reduce drafts and keeps floor-level access areas sealed.
• Improves appearance when the original panel is scratched, dented, or discolored.

• One base panel (lower kickplate) as stated.

• Disconnect power to the appliance before beginning work; follow all electrical and gas safety procedures if applicable.
• Installation typically requires removing the existing kickplate and fastening the new panel with the original screws or clips; keep fasteners organized.
• Use care to avoid scratching the new panel; lift into place and align before tightening.

Door shelf rail for refrigerators. Attaches to the door to support and secure storage bins. Replace if cracked, broken, or no longer holding shelves properly.