Kenmore Refrigerator 106.44434603 (10644434603, 106 44434603) Parts

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

Secure water line connections with this refrigerator hose clamp. Replace if leaking, loose, or corroded. Verify fit with your model number before ordering.

Fix a refrigerator with no interior light using this light socket. Simple DIY repair that takes about 15 minutes with basic tools. Fits most models.

Wire tie secures and organizes internal wiring harnesses in your appliance. Replace if the original tie is broken, cracked, or missing during repairs.

Replacement door hinge for your refrigerator. Installs on the cabinet to support door weight. Needed when hinge is broken, cracked, or worn out.

Discolored or stained dispenser grille? This overflow grille prevents water from leaking into the door liner. Easy 30-second snap-in installation.

Fix a broken or stained water dispenser paddle on your refrigerator. This biscuit-colored lever restores smooth water dispensing in minutes.

Secures panels, brackets, and internal components in your refrigerator. Replace missing, stripped, or corroded screws to restore tight assembly fit.

Crisper drawer won't adjust humidity or slide is broken? This humidity control slide mounts in the crisper cover to regulate airflow and moisture levels.

Small metal washer for refrigerator assemblies. Distributes load under bolts and nuts to keep components secure. Replace if lost, damaged, or worn.

This is a plastic shelf bin that mounts on the inside of your refrigerator door. It holds bottles, condiments, dairy items, and other small food containers for easy access. Replace this bin if it is cracked, warped, or if the mounting tabs have broken, causing it to fall off or sit unevenly on the door.

Shelf cover assembly that installs above the deli/meat drawer in your refrigerator. Replace if cracked, broken, or missing to restore support and function.

This thermostat retainer clip secures the defrost thermostat to the evaporator tubing in your refrigerator or freezer, maintaining firm contact for accurate temperature sensing and dependable defrost operation.

• Holds the thermostat firmly against the evaporator line for proper temperature feedback
• Helps prevent a loose or dangling thermostat that contribute to frost buildup and poor defrost performance
• Restores correct mounting when the original clip is cracked, bent, or missing
• Common signs include a broken clip or a thermostat not attached to the coil

• Disconnect power to the appliance before servicing; wear cut-resistant gloves
• Access the evaporator compartment; remove accumulated frost/ice as needed without prying on coil fins
• Position the thermostat body flat against the tubing and snap the retainer over it, avoiding pinched wires or damaged fins
• Confirm a secure fit and proper wire routing before reassembling and restoring power

Rubber grommet kit that mounts and cushions the compressor. Replace worn, cracked, or damaged grommets to restore proper support and isolation.