Kenmore Refrigerator 106.61482401 (10661482401, 106 61482401) Parts

This defrost thermostat with attached wiring harness monitors the evaporator coil temperature and signals the defrost heater to turn on or off during the defrost cycle. It is typically mounted on or near the evaporator coils inside the freezer compartment. Replace this part if the refrigerator is not cooling properly, frost is building up excessively on the evaporator coils, or the defrost cycle is not functioning correctly.

This is a small white plastic plug that fills the hinge sleeve hole on a refrigerator or freezer door. It covers unused hinge mounting holes to provide a clean, finished appearance, especially after reversing the door swing. Replace this plug if it has cracked, fallen out, or gone missing, leaving an exposed hole in the door.

This is a rubber gasket that seals the connection between the water fill tube and the ice maker assembly inside the freezer compartment. It prevents water from leaking around the fill tube during the ice maker's fill cycle. Replace this gasket if you notice water dripping or ice buildup around the fill tube area, or if water is leaking onto the freezer floor during ice production.

Refrigerator not cooling or clicking but not starting? This compressor start relay provides the initial boost to start your compressor. DIY-friendly repair.

Replacement freezer shelf for top-mount refrigerators. Restores sturdy storage surface when original is cracked, broken, or missing. Organizes frozen foods.

Door hinge butt for top-mount refrigerators. Mounts between cabinet and door to support hinge pin assembly. Replace if cracked, broken, or worn out.

Replacement mounting screw for refrigerator panels, brackets, and trim. Restores secure fit when original screw is stripped, missing, or damaged.

10-32 thread screw that secures interior panels and brackets in refrigerators. Replace when original is stripped, missing, or damaged to restore fit.

Flat washer used on refrigerator door hinge assembly. Reduces friction and distributes load for smooth door operation.

Replace a cracked, broken, or missing hinge cover on your refrigerator. Snaps over the hinge assembly to conceal hardware and restore a clean finish.

This replacement screw secures panels, brackets, and other components in your appliance so they stay tight and properly aligned. Use it to replace missing, stripped, or rusted hardware and eliminate looseness, rattles, or gaps.

• Fastens parts to the cabinet/frame to maintain structural integrity
• Helps keep panels and assemblies aligned to reduce vibration and noise
• Replaces missing, damaged, or corroded screws during service
• Common fix for loose panels or components that no longer hold securely

• Disconnect power and shut off water or gas before servicing
• Match length and thread to the original screw for proper fit
• Hand-start threads to avoid cross-threading; tighten only until snug—do not overtighten
• Tighten them evenly to ensure proper alignment

Size: 8-18 x 1/2 inch.

Door hinge shim adjusts refrigerator door height and alignment at the lower hinge. Replace when worn to restore smooth closing and proper gasket seal.

Replace a broken or loose thermostat control knob that causes temperature control issues. Simple pull-off installation, no tools required.

Size: 8 x 1-1/4 inch.

Almond. Size: 13 oz. can. Acrylic appliance paint.