Kenmore Refrigerator 106.8572813 (1068572813, 106 8572813) Parts

Took the old assembly off and put the new on, just bolts on, very easy. Read more

I took the new seal out of it's packaging and used a blowdryer on low heat to soften up the seal so that the crease from shipping (it was folded to ship) disappeared. Next I took the refrigerator door off, removed the old seal, & cleaned the area where the new seal would be applied. Following the video on the Appliance Pro Parts website, I re-installed the new seal and put the door back on. Last step was to snap on the new hinge cap I ordered. The video online was easy to follow and this... Read more

On our refrigerator the end caps had broken, leaving a flat part of the end cap covering the mounting holes in the door. I drilled through the center of the broken pieces to release the spring tension on the back of the end cap. I could then remove them and install the new end caps onto the bar and then the bar onto the door. On our refrigerator the model number did not match when cross checking with the part number. The picture really helped. Read more

Removed door and replaced hinges Read more

Replaced the limit switch. Read more

I replaced the start relay and overload switch with the single part Overload/Relay part number AP3119971. Now it operates like new. Had no problem replacing part, just followed instructions. I was very pleased at a single part replacement for both, relay and overload. I was expecting just to replace the overload. This is much, mush better. It's been running for over a week with no problems, Read more

The new overload/relay kit corrected the problem. The Panduit/zip-ties supplied in the replacement kit didn't fit where the illustration showed in the directions but smaller zip-ties connected together did fit and held the relay against the compressor just fine and the sealant had good squeeze-out. Read more