Kenmore Refrigerator 106.9610682 (1069610682, 106 9610682) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489478
Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.
Do-It-Yourself Stories from Customers like You
Wanted to update wood paneled compactor Julie S. • San Antonio , TX • December 09, 2014
Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on...
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10250570
Supports your refrigerator at the base and lets you roll it forward for cleaning. Replace this roller assembly if cracked, broken, or seized to restore smooth movement.
Do-It-Yourself Stories from Customers like You
The plastic left rear wheel was coming apart and needed replacing Gary H. • San Antonio , TX • June 11, 2016
I decided if one needed replacing I might as well both two--made sense to me. None were available locally so I ordered them on-line. Surprisingly they came sooner than I expected. I also found a video on the internet that clearly showed the procedure. The actual repairs took 15 minutes or less. One good suggestion from the video was to run the screw in and out of the wheel bracket before final mounting. The video also suggested putting something under the corner to eliminate tipping. The...
Read more
More
$29.48
- Compare At:
-
$34.79
- You Save:
-
$5.31
Genuine Whirlpool part
By: Whirlpool
Part Number: W11233072
This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.
- Fastens panels, brackets, covers, or internal parts to the chassis or frame
- Helps maintain alignment and support, reducing rattle, vibration, or looseness
- Replaces missing or damaged screws that have backed out, broken, or stripped
- Restores secure mounting after service when original hardware is lost
What's included: 1 screw Install notes:
- Disconnect power; shut off water or gas supplies before servicing
- Use the correct driver; start threads by hand to avoid cross-threading
- Match length and thread to the original location; do not substitute with longer hardware
- Tighten snugly; do not overtighten into plastic or thin metal
Do-It-Yourself Stories from Customers like You
Bake element broken on jenn air model s125 downdraft slide in range Patricia D. • Raleigh , NC • May 02, 2015
Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process.
To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -...
Read more
More
$21.46
- Compare At:
-
$25.54
- You Save:
-
$4.08
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2172748
Metal support bar that mounts to the refrigerator liner to hold the crisper cover frame and glass level. Replace if broken, missing, or bent.
Do-It-Yourself Stories from Customers like You
The bar that supports the lower glass shelf and drawers was missing Derek C. • Nashville , TN • January 11, 2015
I had to cut down the length of the bar using a Dremel so that it would fit into the channels, it was originally too wide to fit into the fridge. One thing to note, only cut it as wide as the actual fridge; you can get it into the plastic shelf structure by sliding it too much into one side, and then guiding it into the other side.
Read more
More
$72.95
- Compare At:
-
$87.54
- You Save:
-
$14.59
Genuine Whirlpool part
By: Whirlpool
Part Number: 72032
Bottle with brush. Color: Black. Size: 0.6 fl.oz.
Do-It-Yourself Stories from Customers like You
Leaking diaphragm Herbert S. • Monroe Township , NJ • January 03, 2015
Replaced It With New One
Read more
More
$18.23
- Compare At:
-
$21.88
- You Save:
-
$3.65
Genuine Whirlpool part
By: Whirlpool
Part Number: 1123394
Refrigerator freezing food or not cooling? This temperature control thermostat regulates cooling cycles. Common DIY fix when temps won't stay consistent.
Do-It-Yourself Stories from Customers like You
Running would not stop! stopped would not start! James W. • Norco , CA • May 29, 2017
Ordered a cold thermostat switch and installed it.
Read more
More
$105.36
- Compare At:
-
$125.38
- You Save:
-
$20.02
Genuine Whirlpool part
By: Whirlpool
Part Number: 2188460A
Seals freezer door to cabinet, keeping cold air in and moisture out. Replace if worn, torn, or not sealing properly to restore temperature control.
More
$109.54
- Compare At:
-
$130.35
- You Save:
-
$20.81
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489069
Size: 1/4 inch hex head, 10-12 x 1/2 inch.
Do-It-Yourself Stories from Customers like You
Broken handle foot pedal and missing parts Donald M. • Lake Arrowhead , CA • April 05, 2015
This trash compactor is in our vacation home. We never use it and now we are selling the house. When I looked to replace it I was amazed at how expensive a new compactor would cost. I found the serial number on the current compact entered it and your web site came up. Your schematics were excellent and made the repair very easy!
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2212648
This is a small white plastic plug that fills the hinge sleeve hole on a refrigerator or freezer door. It covers unused hinge mounting holes to provide a clean, finished appearance, especially after reversing the door swing. Replace this plug if it has cracked, fallen out, or gone missing, leaving an exposed hole in the door.
Do-It-Yourself Stories from Customers like You
The handle on the refrigerator door was broken and needed to be replaced Richard W. • Baltimore , MD • April 12, 2015
Took off the freezer door, took off the top hinge on the refrigerator door, replaced the handle, re-installed the top hinge and the freezer door. This is a two person job - one to remove the top hinge and replace the handle, while a second person holds the refrigerator door in place. Replacing the handle was easy. The most irritating part was figuring out what parts to order. The drawing of the refrigerator door (Drawing # 4) used to figure out what parts to order was not clear. I paid $8...
Read more
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: WP1106508
This is a rubber gasket that seals the connection between the water fill tube and the ice maker assembly inside the freezer compartment. It prevents water from leaking around the fill tube during the ice maker's fill cycle. Replace this gasket if you notice water dripping or ice buildup around the fill tube area, or if water is leaking onto the freezer floor during ice production.
Do-It-Yourself Stories from Customers like You
Delivery person broke fitting off for the ice maker while removeing our "good" old fridge that was already sold Donald J. • Fremont , MI • October 13, 2014
I ordered the repair parts that Lowes said they couldn't get. I got the parts very fast and only took 5 minutes to get the job done.
Read more
More
$6.42
- Compare At:
-
$7.70
- You Save:
-
$1.28
Genuine Whirlpool part
By: Whirlpool
Part Number: 819091
This kit includes shelf support studs used to hold shelves securely in place inside the refrigerator or freezer compartment. The supports mount into the interior liner and provide a stable resting point for wire or glass shelves. Replace these if the shelf supports are cracked, broken, or missing, causing shelves to sit unevenly or fall.
Do-It-Yourself Stories from Customers like You
Broken shelf support Jim C. • Hacienda Heights , CA • June 02, 2015
The shelf support was broken for 5 years(!) I had to stack stuff under it in order to hole it up. I finally got fed up and in searching discovered that I could buy the little support to fix it. I only needed one support but the package included all 4.
They just slipped over the protrusion and 'poof' it was fixed! Gee what took me so long? What a relief.
Read more
More
$28.43
- Compare At:
-
$33.55
- You Save:
-
$5.12
Genuine Whirlpool part
By: Whirlpool
Part Number: 4387535
Fridge not cooling but lights work? This compressor overload stops overheating and prevents startup damage. DIY-friendly repair in about 1 hour.
This part fixes the following symptoms
-
Won't start
-
Fridge too warm
See more...
Do-It-Yourself Stories from Customers like You
Overload switch stopped working turning off the refrigerator compressor J Michael L. • Waxahachie , TX • August 06, 2016
Replaced overload switch and start relay with convenient repair set.Video available on website that gave step by step instructions. Followed the video steps for removal and installation.... plugged in the refrigerator compressor started up everything cool in minutes
Read more
More
$87.27
- Compare At:
-
$102.98
- You Save:
-
$15.71
Genuine Whirlpool part
By: Whirlpool
Part Number: W11679940
Fix dim or no interior lighting with this refrigerator light bulb. Restores clear visibility when you open the door. Simple 5-minute replacement.
More
$8.95
- Compare At:
-
$10.74
- You Save:
-
$1.79
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489464
This is a replacement screw designed to work with a wide range of household appliances. It is used for many purposes in these appliances, from holding body panels together to securing electronics into control boards. However, screws are subject to damage through corrosion, impact, and improper installation/removal. In most cases, the primary damage to this screw is through corrosion – it may become rusted or corroded in place, depending on the appliance and the maintenance provided during its lifespan. The screw may also be stripped or rounded due to improper removal or installation. If the screw is damaged, lost, or corroded in place, it will need to be replaced. In most cases, removal will require nothing more than a Phillips head screwdriver or the appropriately sized socket with a ratchet. However, if the screw is damaged, it may require a tap set to remove it from its mounting location. Note that this is a genuine OEM replacement screw made from durable, high-quality metal, and is sold individually. It fits Whirlpool, Maytag, Roper, Estate, Amana, Crosley, and Thermador appliances. It is used in over 150 machines, ranging from washers and dryers to air conditioners.
Do-It-Yourself Stories from Customers like You
Cover unit in back of refrigerator need to be replaced Lawrence T. • Catalina , AZ • March 20, 2016
VERY EASY TO REPLACED OLD COVER-UNIT NEW COVER-UNIT.
Read more
More
$9.63
- Compare At:
-
$11.36
- You Save:
-
$1.73
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8281206
Replacement mounting screw for refrigerator panels, brackets, and trim. Restores secure fit when original screw is stripped, missing, or damaged.
Do-It-Yourself Stories from Customers like You
Lower bracket holding the refrigerator door handle broke Marvin S. • West Hartford , CT • October 24, 2015
REPLACED THE 4 BRACKETS FROM BOTH THE REFRIGERATOR AND FREEZER DOOR(S) HANDLES.
Read more
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76
Genuine Whirlpool part
By: Whirlpool
Part Number: WP488921
This replacement screw secures panels, brackets, and other components in your appliance so they stay tight and properly aligned. Use it to replace missing, stripped, or rusted hardware and eliminate looseness, rattles, or gaps.
- Fastens parts to the cabinet/frame to maintain structural integrity
- Helps keep panels and assemblies aligned to reduce vibration and noise
- Replaces missing, damaged, or corroded screws during service
- Common fix for loose panels or components that no longer hold securely
Includes: 1 screw
- Disconnect power and shut off water or gas before servicing
- Match length and thread to the original screw for proper fit
- Hand-start threads to avoid cross-threading; tighten only until snug—do not overtighten
- Tighten them evenly to ensure proper alignment
More
$7.56
- Compare At:
-
$8.32
- You Save:
-
$0.76