Kenmore Dryer 110.67432600 (11067432600, 110 67432600) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10109200
This replacement screw secures panels, brackets, and other components in your appliance to keep them aligned and rattle-free. Replacing worn, stripped, or missing hardware restores a tight fit and helps maintain safe, quiet operation.
- Fastens panels, brackets, or internal parts to the cabinet/frame
- Helps maintain alignment to reduce vibration and rattling
- Replaces lost, stripped, or corroded screws
- Common symptoms: loose panels/trim, rattles, or a screw that won't tighten
What's included: One screw. Install notes:
- Disconnect power; shut off water or gas if applicable
- Match thread and length to the original; replace one at a time to keep alignment
- Start threads by hand to avoid cross-threading; use the correct driver
- Tighten snugly—do not overtighten, especially into plastic or thin sheet metal
Do-It-Yourself Stories from Customers like You
Missing baffles Anna S. • Shoreview , MN • January 31, 2016
I ordered two replacement baffles and screws, then lifted the top of the dryer to access the drum and installed the two new baffles.
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP681414
Specs: 10-16 x 1/2 inch.
Do-It-Yourself Stories from Customers like You
Dryer drum was beginning to stall occasionally Dana J E. • San Marcos , CA • March 17, 2015
After shopping for a new Whirlpool Thin Twin Stack, Found appliance parts pros online and decided to take it apart to see if repair was a possibility. APPro's online instructions were easy to follow, in a couple hours it was apart, and I placed the order. Reg ground took a week from NY, so the laundry piled up that week. The parts arrived on Monday morrning, by afternoon the machine was running like new! The cause was the belt tensioner pulley had frozen. Replaced it, drum wheels,snap...
Read more
More
$5.95
- Compare At:
-
$7.14
- You Save:
-
$1.19
Genuine Whirlpool part
By: Whirlpool
Part Number: WP660658
This part is a motor clamp. This is a genuine OEM part and has been sourced directly from the manufacturer. This part is intended to replace a deteriorated, damaged, or broken motor clamp on certain makes of indoor appliance models. Motor clamps are essential for properly securing the drive motor on various types of indoor appliances such as washers, dryers, and refrigerators. Without the use of a motor clamp, the drive motor is free to move around or become detached. This can easily cause serious damage to the equipment and prevent proper functionality. Proper tools are needed to replace this part and appropriate safety measures should be adhered to when working on any type of equipment. For accurate information on how and where to install this replacement motor clamp, specific manufacturer diagrams should be referred to.As an authentic replacement part, this motor clamp can be used on multiple different models of washers, dryers, refrigerators, and washer/dryer combos manufactured by Kenmore, Maytag, Whirlpool, and Amana. Please note that this motor clamp is a genuine part made of high-quality materials and is sold individually.
Do-It-Yourself Stories from Customers like You
Motor locked up and was buried in lint due to the felt seal failing and letting lint into the motor area. Steven O. • Shrewsbury , MA • February 06, 2022
Replaced the motor, blower, rear drum felt seal, and drive belt. Vacuumed up the lint everywhere, cleaned extra lint out of the chute, around the blower, and rear vents.
Read more
More
$10.37
- Compare At:
-
$12.44
- You Save:
-
$2.07
Genuine Whirlpool part
By: Whirlpool
Part Number: 279220
Includes two bumpers and two locking clips. You will use one or the other depending on hole size.
Do-It-Yourself Stories from Customers like You
Gas dryer did not heat and excessive lint inside the unit James C. • New Boston , MI • July 20, 2017
Our 19 year old Whirlpool dryer quit heating. After checking the thermal fuse, I found the ignitor electrically open. I bought an ignitor at a local store as there was a national holiday the next day and I did not want the dryer inoperative waiting several days for shipping. I can say AppliancePartsPros is MUCH cheaper for the identical Whirlpool genuine part. While changing the ignitor, I noticed there was an excessive amount of lint in the dryer, which was caused by worn drum seals. I ordered...
Read more
More
$12.32
- Compare At:
-
$14.54
- You Save:
-
$2.22
Genuine Whirlpool part
By: Whirlpool
Part Number: W11226088
Covers and protects your dryer's light bulb from heat and debris while diffusing illumination. Replace if cracked, yellowed, or missing. Confirm fit.
Do-It-Yourself Stories from Customers like You
The pulley wheel the light cover James B. • Philadelphia , PA • August 06, 2017
Been doing these repairs for a lil while now. Your Company provides Videos on Appliance Brands that detail how to get to the part that is suspected and how to Test and Repair. I suspected a Part by it's sound and followed the Video to get to the part and made the repair.
Read more
More
$26.21
- Compare At:
-
$31.45
- You Save:
-
$5.24
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3388703
This flat support washer provides a stable bearing surface under a fastener. Its 1-1/2-in diameter helps distribute load, maintain spacing, and keep components aligned so hardware stays tight and assemblies operate smoothly. What it does:
- Distributes clamping force to prevent pull-through and gouging
- Maintains proper spacing and alignment between mating parts
- Helps reduce vibration, rubbing, or wobble from a loose assembly
- Replaces a cracked, deformed, or missing support washer
What's included:
Install notes:
- Disconnect power and shut off water/gas before servicing.
- Note the order and orientation of any washers/spacers during disassembly.
- Inspect mating hardware and surfaces; replace any worn or damaged parts.
- Tighten fasteners to manufacturer specifications—do not over-tighten.
Do-It-Yourself Stories from Customers like You
Drum support bearing failure. Myron D. • Covington , KY • July 13, 2018
Simple fix, right parts fast.
Read more
More
$4.95
- Compare At:
-
$5.89
- You Save:
-
$0.94
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3404162
Fixes excessive vibration and rattling from dryer motor movement. This clamp secures the motor to its bracket, restoring stability. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Motor locked up and was buried in lint due to the felt seal failing and letting lint into the motor area. Steven O. • Shrewsbury , MA • February 06, 2022
Replaced the motor, blower, rear drum felt seal, and drive belt. Vacuumed up the lint everywhere, cleaned extra lint out of the chute, around the blower, and rear vents.
Read more
More
$5.95
- Compare At:
-
$7.02
- You Save:
-
$1.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WP692490
Plastic drum baffle that lifts and tumbles clothes during drying. Replace if cracked, broken, detached, or missing from inside your dryer drum.
Do-It-Yourself Stories from Customers like You
Baffle detached stripped screw holes Judith R. • Chandler , AZ • August 09, 2014
I installed it my self by watching your video
Read more
More
$70.34
- Compare At:
-
$83.70
- You Save:
-
$13.36
Genuine Whirlpool part
By: Whirlpool
Part Number: W11233063
Factory protective shield panel for dryer assembly. Guards internal components and directs heat or airflow. Replace if cracked, broken, or missing.
Do-It-Yourself Stories from Customers like You
The seals were worn. Anthony C. • Bentonia , MS • November 14, 2023
I changed the thermostat and replaced the worn out seals.
Read more
More
$14.56
- Compare At:
-
$17.18
- You Save:
-
$2.62
Genuine Whirlpool part
By: Whirlpool
Part Number: W11684613
Replace a cracked or missing bracket to keep appliance components securely mounted and aligned. Restoring this support helps prevent movement, vibration, and premature wear, so the connected part operates as intended.
- Provides a rigid mounting point for an associated component or assembly
- Maintains correct alignment and spacing within the appliance
- Helps reduce vibration, rattling, or shifting during operation
- Replaces brackets that are cracked, bent, or broken
- Common signs: loose or wobbly parts, misalignment, rattling noises, or visible bracket damage
What's included: 1 bracket Installation notes:
- Disconnect power; also shut off the water supply before servicing
- Wear cut-resistant gloves—bracket edges can be sharp
- Reuse original screws/clips unless replacements are specified
- Hand-start fasteners, align parts, and tighten evenly without overtightening
Do-It-Yourself Stories from Customers like You
Drive belt support rollers and idler pulley worn. Carlos W. • Port Orchard , WA • May 30, 2020
Disassembled dryer, replaced worn parts and reassembled dryer.
Removed top cover, disconnected front connector, removed front panel, removed belt from idler pulley, removed washer drum and belt, replaced push clip, retaining clips, 2 support rollers and idler pulley. Reassembled in reverse order.
Read more
More
$17.95
- Compare At:
-
$21.36
- You Save:
-
$3.41
Genuine Whirlpool part
By: Whirlpool
Part Number: W11693756
Type AB #8-18 x 5/8 inch thread-forming screw secures panels and components in appliances. Replace missing, stripped, or corroded fasteners.
Do-It-Yourself Stories from Customers like You
Door switch on dryer. James A. • Middleburg , FL • January 20, 2020
It was very easy to fix after watching your video..
Read more
More
$10.95
- Compare At:
-
$12.92
- You Save:
-
$1.97
Genuine Whirlpool part
By: Whirlpool
Part Number: W11736322
This replacement cover restores the appliance's finished appearance and protects internal components from dust and debris. It's a direct-fit exterior trim piece designed to replace a cracked, broken, or missing cover. What it does:
- Protects internal components and wiring from debris and accidental contact
- Restores the appliance's cosmetic appearance and helps maintain sealing
- Helps reduce dust buildup in the covered area
- Replaces damaged or missing trim that can expose sharp edges or hardware
What's included: One outer cover Install notes:
- Disconnect power (unplug or switch off circuit breaker) before beginning work
- Basic hand tools may be required; follow for panel removal/replacement
- Handle carefully to avoid scratching the finish and watch for sharp edges
- Replace with manufacturer-recommended fasteners
Do-It-Yourself Stories from Customers like You
Broken coupling half Neal F. • W Portsmouth , OH • February 27, 2026
Replaced broken coupling with new coupling
Read more
More
$27.95
- Compare At:
-
$33.20
- You Save:
-
$5.25
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8066217
Supports and pivots the hinged dryer top panel for service access. Replace if cracked, broken, or causing wobble, scraping, or alignment gaps.
Do-It-Yourself Stories from Customers like You
Would not spin Andrew M. • Long Island City , NY • December 18, 2015
Replaced belt and idler arm, just to be safe.
Read more
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: W10850756
Replacement screw secures panels, brackets, and internal assemblies. Needed when original hardware is stripped, corroded, or missing to keep parts tight.
More
$5.95
- Compare At:
-
$7.08
- You Save:
-
$1.13
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3403636
Short baffle that mounts inside the dryer drum to lift clothes as the drum rotates. Replace if cracked, broken, or missing for proper tumbling action.
Do-It-Yourself Stories from Customers like You
The dryer will me a buzzing but wouldn't turn Jose B. • Berkeley , CA • April 02, 2017
I watched You Tube and it gave me an idea of what was was wrong.. The motor was frozen. There was not room here to comment about the service that I received . It is only one word fantastic, from the time I started chat with the rep to the time I finished. Amazing. I order the part on Tuesday and I received the parts on Wednesday. That night when I came back from work, I fixed . Everybody at home was happy that the dryer was back in business. Thank you guys and the amazing Representative that...
Read more
More
$64.22
- Compare At:
-
$77.06
- You Save:
-
$12.84
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10362431
Door hinge pin assembly for dryers. Provides the pivot point for your dryer door, supporting its weight during opening and closing. Replace if bent or worn.
Do-It-Yourself Stories from Customers like You
Broken dryer door hinges. Aaron G. • Westbrook , ME • January 08, 2023
I had to unscrew the old hinges and replace with these new ones. Fit was perfect!!
Read more
More
$9.41
- Compare At:
-
$11.29
- You Save:
-
$1.88