Kenmore Refrigerator 253.51694102 (25351694102, 253 51694102) Parts

Previously, I removed the lower rear cardboard back of the unit and saw the crack in the defrost pan. It was probably damaged when unit was moved using appliance hand truck. I looked up the part number AP4319611 in the exploded view diagrams of the unit. The part was ordered and delivered in a few short days. Emptied the unit and removed all shelves/glass to avoid damage since the unit must be tilted enough to reach under and remove two 1/4 inch hex screws. Tilted to the right side (facing... Read more

I ordered online to AppliancePartPros.com for the fridge door hinge and after quick delivery I spent 15 minutes to securely fit the door back on the frig. I'm sure to do business again for parts if needed. Read more

Replaced motor and new solenoid and yoke assembly, motor ran fine but Ice maker did not make Ice, water was turned on and the wire off and on latch was is the down position (on). Disconnected the water line from the Ice maker tray, ice had formed in the line while I was waiting for my parts (about 5 days), I would suggest disconnecting the water line at the feed end were your shut off valve is located and allow water to drain out of line. I had to remove Ice tray and submerge it pan of hot... Read more

This is the second time of needing repair. I remove the ice bucket, open the crusher, remove the 5 blades. Straighten the blades, reinstall. I then order new blades, The next time it happens I will install the new blades. The reason for the malfunction, (my guess), two ice cubes partially melted stick together and the size and angel the enter crusher cause the problem. I don't see it as the crusher problem or the blades being to weak. The ice container gets over full, opening and closing the... Read more

Defrost heater and thermostat. Read more

Replaced the gear. Now it's making ice again. Perfect. Read more

I ordered (3) new replacement blades and received them in two days! Read more

Removed top hinge then removed door. Replaced hinge closure cam and bearing. Read more

It worked good Read more

Shelving went in without a problem. Very simple. Checked the installation video anyway in case there was a trick to not breaking something. Learned that the nylon clips needed to be transferred and found one missing on another shelf, so ordered a replacement. The water valve was one I replaced some time ago but one of the solenoids was bad, confirmed with a meter (ohm reading is between 200-500; less than 200 or more than 500 is broken). Replaced it without a problem (becoming expert at... Read more

Initially I noticed the crusher drum was cracked and broken so I replaced the drum the retaining nut on the end of the auger and the circlip and washer. it worked fine for a time and then the drum began free wheeling. upon further inspection I discovered the retain nubs on the auger had worn down allowing the blade to slip down the auger body. so I replaced the auger, drum, drive blade, and drive cam. I recommend if you gave a problem with the ice dispenser you break down and inspect the entire... Read more

REPLACED BUSHINGS ON TOP & BOTTOM REF. DOOR Read more

This was a simple replacement of the crisper drawer and humidity control sliding switch; easy to snap into place and align with the tracks. Read more

My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more