Kenmore Refrigerator 363.58042890 (36358042890, 363 58042890) Parts

• Ice maker not making ice
• Ice maker won't dispense ice
• Leaking

Much easier than expected, I was certain it had to be a water line but the solved everything Read more

We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from... Read more

I ordered a new switch from APP and fixed my fridge. However, the video posted for this repair on this site is not applicable to newer refrigerator models. I have a 2015 GE GTE18IHCRSS and had to drop the control housing (#432 in the diagram) to attach the wire/plug assembly to the switch. Only had to remove the front screw with a 1/4" nut driver and that provided enough of a gap for me to plug in the switch. So the correct method to replace the light switch in a newer model refrigerator is as... Read more

• Fridge runs too long
• Door won't open or close
• Door sweating

I followed the directions on the video.....had to look at it a couple of time. Difficult to work lying on the floor for me, but the technique was spot on. I have now replace the door closing cams on the refrigerator door and the freezer door of the side by side unit. Thanks for such great instructions. Read more

I changed the motherboard - computer and also changed the motor in the freezer, because it was doing a howling sound every time it turned on. The repair technician asked for $500 for a repair and that is on top of the $230 I paid him two days before. I looked up the parts and decided to try myself and it paid off. Great instructional videos. Thanks Read more

• Door sweating
• Door won't open or close

I determined that the cam riser had broken into two pieces. Finding the part was easy on the diagram on the website. It arrived less than 24 hours after it was ordered. Top hinge was removed and the door was placed on a set of horses. One bolt was removed from the bottom of the door, the pieces of the broken cam riser were removed and the new one installed. Door was replaced and top hinge rebolted. The door was off for about 5 minutes. I was very pleased with the service of Appliance Parts... Read more

• Freezer not defrosting
• Freezer section too warm

We saw that the ice cream in the freezer was soft and the main refrigerator section was not cold enough. Called for repair but soonest appointment was a full week away. So I spent the next few hours online learning how to diagnose and repair refrigerators. When I opened up the back of freezer compartment to access the evaporator coils, I found ice and frost totally blocking the cold air flow. Turns out the bottom one of the two heater bulbs (quartz heater bulbs) was bad, so both heater bulbs... Read more

Ordered the part through e-mail based on the model number of the frig. When the part arrived,I looked at the set up from the right side and follwed the process for the right. Took me one minute. Read more

I ordered the bucket and it was on my door step the next afternoon, Read more

I found that the Ice Maker in my GE side by side made ice but would not kick out the ice when it had formed, the heating element or the switch that controls it didn't work. I ordered a new ice maker switched it out took less than 3 minutes. The cord was very stiff and just long enough but I got it to connect and in 35-40 minutes I had fresh ICE!! Read more

• Noisy

I used a set of ring pliers to remove the old retaining ring, then spread the plastic ribs around the fan motor shaft with a small flat bladed screwdriver to ease removal of the old fan blade. I reversed the process to replace the blade, gently tapping a socket from my socket wrench set placed over the motor shaft and ribs with a small rubber mallet. I stopped when the shaft protruded about 1/8" beyond the plastic ribs of the new fan blade, then installed the new retaining clamp ring with the... Read more

Replaced compressor with kit an relay, capacitor. Read more

Originally replaced the door and spring but it still would not close. This time, replace the solenoid and it works great!!! Read more