Kenmore Refrigerator 363.58062897 (36358062897, 363 58062897) Parts

The replacement was made to fit various models. None of the instructions really fit my model. Ended up spending less time actually replacing it than reading the instructions. Took about 15 minutes. Needed a zip tie to hold the wires to back, otherwise the ice drawer would not shut. Works great, faster than the original, makes 8 cubes every 40 minutes. Ice feeler seems more flimsy than the old design which was a lift up wire. New design is a plastic paddle with an on off switch, which could... Read more

Parts arrived ahead of schedule and repair was made by replacing pad support and actuator pad. Parts worked as advertised. Read more

The ice dispenser door was not closing tightly. As a result, there was frost build up in the ice chute, which also was allowing ambient air and temperature into the freezer compartment. Upon further inspection, there was black “schmutz” on the ice door, and the rubber ice funnel and deflector parts were deteriorating. Because the door was not closing tightly, I also assumed that the door-closing spring was week. The parts I ordered were: ice door assembly, ice funnel, ice deflector, spring and... Read more

Ordered parts and watched the video. Read more

This recess heater was a last resort 'nuclear' option that I never employed. First repair was to replace the solenoid that keeps the little door from staying open and letting room air back up it. Also replaced the gaskets around both doors which allowed the freezer and fridge sides to stay at the right temp. That seems to have done the trick. To install this part would be a herculean task involving complete and total disassembly of the door and seal 'tracks'...this seemed fraught with... Read more

Replaced control board Read more

Replaced motor took 15 minutes, it was great saved 370 dollars. Read more

Drilled out the rivets on the rear of the bucket shelf on each side (needed an angle drive drill for the left side) and removed the front screws. Installed the new shelf both sides with original screws in the front and 8-32 bolts and nuts in the rear. 3 screws to install the bucket to the auger assembly. Read more

Drilled out the rivets on the rear of the bucket shelf on each side (needed an angle drive drill for the left side) and removed the front screws. Installed the new shelf both sides with original screws in the front and 8-32 bolts and nuts in the rear. 3 screws to install the bucket to the auger assembly. Read more