Kenmore Refrigerator 363.58067891 (36358067891, 363 58067891) Parts

I researched the problem and determined that the only thing that can cause this was compressor bad or not starting. Since it was cold the day before I felt it had to be the starter parts and ordered them. It was also very important to clean the coil which I believe caused the over heating. Read more

The ice dispenser door was not closing tightly. As a result, there was frost build up in the ice chute, which also was allowing ambient air and temperature into the freezer compartment. Upon further inspection, there was black “schmutz” on the ice door, and the rubber ice funnel and deflector parts were deteriorating. Because the door was not closing tightly, I also assumed that the door-closing spring was week. The parts I ordered were: ice door assembly, ice funnel, ice deflector, spring and... Read more

Drilled out the rivets on the rear of the bucket shelf on each side (needed an angle drive drill for the left side) and removed the front screws. Installed the new shelf both sides with original screws in the front and 8-32 bolts and nuts in the rear. 3 screws to install the bucket to the auger assembly. Read more

Simple/easy repair. got the right parts (new slides) and replaced them, 2 sheet metal screws per slide. took about twenty minutes, which included cleaning up the bottom of the fridge. Read more

Simple/easy repair. got the right parts (new slides) and replaced them, 2 sheet metal screws per slide. took about twenty minutes, which included cleaning up the bottom of the fridge. Read more

Simple/easy repair. got the right parts (new slides) and replaced them, 2 sheet metal screws per slide. took about twenty minutes, which included cleaning up the bottom of the fridge. Read more

I removed the drawers and old rails, and screwed in the new ones. It was very straightforward. Read more

From the AppliancePartsPros web site I found that 80% of the time either one or both of the defrost heater or timer caused these symptoms. Ordered and received the parts in less than 2 days. Replaced both parts in less than 2 hours without any hassles. Only 48 hours have past but all is operating with the proper temperatures. The most likely failure was the defrost heaters, they were totally blackened when removed and the new ones were clear glass when installed. I have no way of knowing... Read more

Ok so my mom called GE and a service man came out. He said no good. The refrigerator was to old to be fixed. You will have to buy a new one .. ok so with that said he collected his $100 dollars service fee !!! I slid the refer out and started tinkering with it. I went on line and hit your web page saw schematic map and ordered fan motor because the one on refer wouldn’t turn !!!! You guys delivered it on a Sunday ( perfect) I put it in carefully and bam it worked. I was in shock that it was... Read more

Replaced the deflector Read more

Swapped it out for new tube. Take 5 minutes and zero effort. The drain tube will clog with mold. You can clean it out but the tube will clog again despite's you best efforts as the tube wall provide a great habitat. Ordered new tubes to facilitate swap-outs. Old tubes can be cleaned but will recolonize quickly. Read more

Found that piece of auger was broken up front. Ordered auger and several other parts associated with ice maker just to be sure. Also replaced condenser motor which was making noise. Read more