Kenmore Refrigerator 363.58251891 (36358251891, 363 58251891) Parts
Genuine Ge part
By: Ge
Part Number: WR01X10618
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
Do-It-Yourself Stories from Customers like You
Ice dispenser wouldn't dispense ice Chris K. • Felton , DE • April 29, 2025
The auger gearbox shaft had a spot that was stripped of threads which prevented the auger drive from spinning the ice down the chute. I replaced the auger motor/gearbox assembly, the auger drive as it had to be cut off the shaft, and the 3 mount bolts that hold it all in place. Whole job took 30 minutes from start to finish which included cutting off the drive bracket.
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Genuine Ge part
By: Ge
Part Number: WR17X4358
Internal water storage reservoir for refrigerator dispensers. Installs inside the fresh food compartment. Replace if cracked, leaking, or split.
Do-It-Yourself Stories from Customers like You
Nasty water tank for fridge dispenser Prather, T. • Minden , NV • September 22, 2014
This part was easy to install by following the directions from other users here. As long as you get the right hoses connected in the right places, everything else was straight forward. Takes a few minutes for the tank to initially fill and pressurize and clear the air in the line and then you're on your way to clean fresh water!
Read more
More
$111.26
- Compare At:
-
$134.34
- You Save:
-
$23.08
Genuine Ge part
By: Ge
Part Number: WR2X4754
Secures water and drain tubing to prevent leaks, noise, and vibration. Replace if loose, cracked, or missing. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
Genuine Ge part
By: Ge
Part Number: WR1X1367D
Includes 12 retainer rings.
Do-It-Yourself Stories from Customers like You
A fin on the plastic auger broke off and needed to be replaced John M. • Massanutten , VA • August 08, 2015
I ordered a replacement auger from AppliancePartsPros.com. Upon receipt of the new auger, I watched the repair video and took the ice crusher apart. I found several other parts that needed to be replaced as well. Once All the parts were received, I again watched the video. The video was not specific enough to show how to reassemble the ice crusher blades and the two types of washers. I found another video on YouTube that walked me through specific details of assembly and everything went...
Read more
More
$13.79
- Compare At:
-
$16.41
- You Save:
-
$2.62
Genuine Ge part
By: Ge
Part Number: WR1X5278
Secures refrigerator wiring to prevent chafing and vibration noise. Replace when damaged or missing to keep harnesses organized. Confirm fit by model.
More
Genuine Ge part
By: Ge
Part Number: WR2X7309
This solenoid saddle is a small mounting bracket that secures a refrigerator solenoid in the correct position. By preventing movement and misalignment, it helps the linked mechanism engage smoothly and consistently.
- Secures the solenoid to its housing or frame to prevent shifting
- Maintains proper alignment for reliable actuation
- A worn or broken saddle can cause buzzing/chattering and intermittent operation
- Restores stable mounting to help the connected mechanism work correctly
What's included: 1 solenoid saddle Install notes:
- Disconnect power; shut off water supply if working near water lines
- Access the solenoid assembly and note the original saddle's orientation
- Transfer the solenoid into the new saddle and reuse existing fasteners/clips
- Smooth operation before reassembling panels
Do-It-Yourself Stories from Customers like You
Ice dispenser crushing ice only no cubes Eric W. • Copper Canyon , TX • June 27, 2014
Easy fix once I found the problem. Broken solenoid sleeve. Part cost $2.58 + shipping. 10 minute repair.
Read more
More
$7.95
- Compare At:
-
$9.46
- You Save:
-
$1.51
Genuine Ge part
By: Ge
Part Number: WR17X10273
Ice storage bin holds and stores ice produced by the refrigerator's ice maker so cubes are ready for dispensing and stay contained. Replaces cracked, broken, or missing bins to restore normal ice storage and delivery. What it does:
- Collects and stores ice made by the ice maker so cubes are available for dispensing.
- Guides ice toward the dispenser/auger area and helps prevent ice from spilling into the freezer.
- Restores proper ice containment when the original bin is cracked, warped, or missing.
- Helps reduce ice clumping and jams caused by broken or misaligned storage containers.
What's included: One ice storage bin. Install notes:
- Disconnect power to the refrigerator before removing or installing the ice bin.
- Remove shelves or drawer(s) as needed for access; lift out the old bin carefully to avoid damaging the ice maker or dispenser components.
- Align tabs and guides on the new bin and slide into place without forcing; listen for the bin to seat properly.
- After installation, restore power and run the ice maker/dispenser through a test cycle; discard the first batch of ice after reinstallation.
Do-It-Yourself Stories from Customers like You
Ice box door was brokeni Charles S. • Charlotte , NC • October 23, 2017
Order the new one and put it on
Read more
More
$42.41
- Compare At:
-
$50.89
- You Save:
-
$8.48
Genuine Ge part
By: Ge
Part Number: WR17X4207
Ice crusher not working or slow crushed ice production? This helix front feeds ice to crushing blades. Moderate DIY repair—replace with auger for best results.
Do-It-Yourself Stories from Customers like You
Ice crusher repair GE Monogram counter depth. Glenn J. • El Cajon , CA • July 27, 2020
This was a very easy repair, the on-line video at AppliancePartsPros.com was helpful.
The Helix was spinning freely (meaning, the Auger Blade was not holding it in place on the Auger).
Pulling the assembly apart was a snap, and very logical (the video is perfect if you get lost).
The family is now enjoying both crushed and cubed ice - and the redesign of the Auger Blade seems to prevent clogging in the ice shoot.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR23X427
Freezer light not turning on or off? This door light switch activates interior lighting when opened. Moderate DIY repair—press tab, rotate out old switch.
Do-It-Yourself Stories from Customers like You
Freezer light not working. Donnie C. • Bonifay , FL • January 26, 2020
Replaced switch light freezer..
Read more
More
$73.40
- Compare At:
-
$88.08
- You Save:
-
$14.68
Genuine Ge part
By: Ge
Part Number: WZ4X241D
Includes 12 screws. Size: 8-18 ab.
Do-It-Yourself Stories from Customers like You
We didn't have a power cord for our dryer Heather B. • Dulce , NM • October 27, 2018
Ordered the cord through appliance parts pros, with additional screws and it works! Yay after waiting months and everywhere was out. Thank you.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD2X5166
Size: 10-16 ab.
Do-It-Yourself Stories from Customers like You
The shaft seal was leaking when dishwasher emptied Joe V. • Medford , NY • February 07, 2016
Ordered the necessary parts to fix it
Read more
More
Genuine Ge part
By: Ge
Part Number: WR2X4138
Mounting spacer maintains proper clearance between refrigerator panels, doors, or components. Replace if cracked, broken, or missing to restore fit.
More
$15.41
- Compare At:
-
$18.34
- You Save:
-
$2.93
Genuine Ge part
By: Ge
Part Number: WR2X7905
Seals the ice bucket to prevent spills, frost buildup, and water pooling. Replace when ice shifts or water collects. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
The augor in the ice maker was rusty Angie K. • Greenwich , CT • November 15, 2015
Changed the part with SS part.
Read more
More
$10.07
- Compare At:
-
$11.94
- You Save:
-
$1.87
Genuine Ge part
By: Ge
Part Number: WZ5X158D
Size: 8-32 t. Includes 12 screws.
More
Genuine Ge part
By: Ge
Part Number: WR01X10623
Replacement 8-18 x 9/16 machine screw for securing panels, brackets, and internal components. Needed when fasteners are stripped, missing, or worn.
Do-It-Yourself Stories from Customers like You
Bottom kick plate was missing. Robert G. • Apopka , FL • February 28, 2021
REPLACED IT WITH A NEW ONE.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR01X10019
6 - 10 pl flp 1/2 s
Do-It-Yourself Stories from Customers like You
We damaged our dispenser lever & shield when water service quit & line froze up Geoffrey B. • Hammond , OR • March 08, 2019
Replaced water line & both damaged dispenser parts.
Read more
More
$7.95
- Compare At:
-
$9.54
- You Save:
-
$1.59