Kenmore Refrigerator 363.58472890 (36358472890, 363 58472890) Parts
Genuine Ge part
By: Ge
Part Number: WR30X30972
Ice maker not producing ice or won't dispense cubes? This complete ice maker assembly replaces failed units. DIY-friendly install in under 10 minutes.
Do-It-Yourself Stories from Customers like You
Ice maker would not exspell the ice after it was made. Leesinger K. • Jackson , WI • April 03, 2014
I found that the Ice Maker in my GE side by side made ice but would not kick out the ice when it had formed, the heating element or the switch that controls it didn't work. I ordered a new ice maker switched it out took less than 3 minutes. The cord was very stiff and just long enough but I got it to connect and in 35-40 minutes I had fresh ICE!!
Read more
More
$200.72
- Compare At:
-
$238.86
- You Save:
-
$38.14
Genuine Ge part
By: Ge
Part Number: WR2X8474
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
This part fixes the following symptoms
-
Leaking
-
Ice maker not making ice
See more...
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$32.95
- Compare At:
-
$39.21
- You Save:
-
$6.26
Genuine Ge part
By: Ge
Part Number: WR51X443
Ice buildup in freezer? This defrost heater and thermostat assembly melts frost from evaporator coils. Moderate DIY repair restores proper cooling.
Do-It-Yourself Stories from Customers like You
Defrost heater not working Jayesh P. • La Canada , CA • June 12, 2014
I replaced defrost heater with thermostat. It is a very easy and there is YouTube tutorial video for that.
Read more
More
$130.76
- Compare At:
-
$154.30
- You Save:
-
$23.54
Genuine Ge part
By: Ge
Part Number: WR60X225
Refrigerator not cooling or compressor overheating? A failed condenser fan motor is often the cause. This repair takes about 10 minutes with basic tools.
Do-It-Yourself Stories from Customers like You
Condenser fan motor failed Michael P. • Riverview , FL • November 09, 2015
Resurched the Needed part. Found Appliance parts pro had the best price. Ordered the part at 2:47pm pm on Thursday. Confirm email immedately received. Shipped email received in less then two hours. Item dropped at my door 1:00pm next day. I only paid for regular shipping. Very impressive. Great job, Thanks
Read more
More
$263.95
- Compare At:
-
$316.74
- You Save:
-
$52.79
Genuine Ge part
By: Ge
Part Number: WR55X24065
Fix a refrigerator that won't start or clicks repeatedly. This compressor capacitor stores energy to start the motor. DIY repair typically takes 30 minutes.
This part fixes the following symptoms
-
Won't start
-
Freezer section too warm
See more...
Do-It-Yourself Stories from Customers like You
Overload was smoking Ken P. • Kent , OH • December 13, 2018
Replaced overload, and capacitor
Read more
More
$48.95
- Compare At:
-
$58.74
- You Save:
-
$9.79
Genuine Ge part
By: Ge
Part Number: WR2X8818
The recess door retainer secures the dispenser's ice chute flapper in the refrigerator door. Replacing a cracked or missing retainer restores proper flapper pivot and sealing to help reduce frost buildup and air leaks around the dispenser.
- Holds the recess/ice door on its pivot within the dispenser assembly
- Helps the flapper close fully to seal the ice chute
- Restores smooth open/close action of the dispenser door
- Common symptoms: loose or fallen flapper, poor chute seal, frost or condensation in the dispenser area, and ice clumping near the chute
What's included: 1 recess door retainer Install notes:
- Unplug the refrigerator before servicing the dispenser
- Carefully remove the dispenser bezel/control panel to access the ice chute door assembly
- Note spring orientation and retainer position; transfer components to the new retainer
- Verify flapper movement and seal before reassembly and restoring power
Do-It-Yourself Stories from Customers like You
Yes ice was not coming out of the dispenser Jason S. • Goose Creek , SC • December 02, 2014
I replaced the solenoid, door, spring and bucket. The bucket cracked from ice freezing inside it. Ice froze inside the bucket because the solenoid stopped pulling the door closed which allowed hot humid air into the freezer. While I was in there I replaced the dispenser door, spring and crank because they are cheap and the old ones were moldy. The mold is most likely from the door not closing and causing condensation on the parts as well.
Read more
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Genuine Ge part
By: Ge
Part Number: WR2X9561
Fix a light that won't turn on or flickers in your refrigerator. This E12 socket replacement is straightforward with our step-by-step video guide.
Do-It-Yourself Stories from Customers like You
Ice maker would not dispense ice and chute/container would frost over Theo S. • Tallahassee , FL • October 01, 2014
When diagnosing the problem, I discovered that the ice door was not properly sealing and that the solenoid had appeared to rust/corrode forcing the door open.
I replaced most of the ice dispenser internals (solenoid, crank, door, and spring) following the video.
The door will now open when dispensing ice (which it does!), and will oddly stay open for a few seconds once I am finished, but does seal properly and the chute/container no longer frosts over.
Read more
More
Genuine Ge part
By: Ge
Part Number: WR62X107
Door solenoid with plunger.
Do-It-Yourself Stories from Customers like You
When dispensing ice from the ice maker, the solenoid was buzzing loudly. It was also rusting badly. Brian B. • Hudson , NH • March 28, 2014
I ordered a new solenoid and when it arrived, I installed it as follows: I cut the power to the refrigerator. I then pulled off the rubber boot (and it's plastic frame) that covers the water switch. Then I removed the bezel that covers the front of the ice maker controls by pulling it straight out. Then I removed the four screws found on the assembly under the bezel. After pulling the assembly forward a bit, I detached the multi-wire connector attached to it and put the assembly aside....
Read more
More
$73.95
- Compare At:
-
$88.00
- You Save:
-
$14.05
Genuine Ge part
By: Ge
Part Number: WR87X20798
Refrigerator not cooling or compressor clicking on and off? This compressor kit restores cooling. Requires certified technician with specialty tools.
More
$489.52
- Compare At:
-
$577.63
- You Save:
-
$88.11
Genuine Ge part
By: Ge
Part Number: WR60X10262
This replacement motor powers the dispenser's auger/crusher mechanism to move ice from the bucket to the chute. Replacing a weak or seized motor helps restore reliable cube or crushed-ice dispensing from the freezer door.
- Drives the ice auger/crusher to feed ice from the bucket through the dispenser chute
- Helps deliver cubes or crushed ice, depending on the control selection
- Common symptoms: no ice dispensing, auger not turning, loud humming or grinding, intermittent or weak dispensing
- Located in the freezer-door dispenser assembly and engages the ice bucket coupler
What's included: One dispenser crusher motor. Install notes:
- Disconnect power to the refrigerator before servicing
- Remove the ice bucket and dispenser trim/panel to access the motor; note wire orientation and fasteners
- Transfer any mounting hardware or coupler from the old motor
- Reassemble, restore power, and test ice dispensing
Do-It-Yourself Stories from Customers like You
Needed new ice maker motor and circuit board Edward Z. • Berlin , CT • August 19, 2016
I watched the help videos first, then ordered the parts, and installed all items as in the video.
Read more
More
$151.67
- Compare At:
-
$178.97
- You Save:
-
$27.30
Genuine Ge part
By: Ge
Part Number: WR01X10631
Replacement mounting screw for refrigerator panels, brackets, and hardware. Restores secure fit when original is missing, stripped, or corroded.
Do-It-Yourself Stories from Customers like You
Door did not seal closed Sharon F. • West Hills , CA • September 17, 2018
Hinge missing screws. Replaced 2.
Perfect now
Read more
More
$5.95
- Compare At:
-
$8.36
- You Save:
-
$2.41
Genuine Ge part
By: Ge
Part Number: WR17X4358
Internal water storage reservoir for refrigerator dispensers. Installs inside the fresh food compartment. Replace if cracked, leaking, or split.
Do-It-Yourself Stories from Customers like You
Nasty water tank for fridge dispenser Prather, T. • Minden , NV • September 22, 2014
This part was easy to install by following the directions from other users here. As long as you get the right hoses connected in the right places, everything else was straight forward. Takes a few minutes for the tank to initially fill and pressurize and clear the air in the line and then you're on your way to clean fresh water!
Read more
More
$122.48
- Compare At:
-
$146.98
- You Save:
-
$24.50
Genuine Ge part
By: Ge
Part Number: WR2X4754
Secures water and drain tubing to prevent leaks, noise, and vibration. Replace if loose, cracked, or missing. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$6.95
- Compare At:
-
$8.36
- You Save:
-
$1.41
Genuine Ge part
By: Ge
Part Number: WR1X5278
Secures refrigerator wiring to prevent chafing and vibration noise. Replace when damaged or missing to keep harnesses organized. Confirm fit by model.
More
Genuine Ge part
By: Ge
Part Number: WR17X4207
Ice crusher not working or slow crushed ice production? This helix front feeds ice to crushing blades. Moderate DIY repair—replace with auger for best results.
Do-It-Yourself Stories from Customers like You
Ice crusher repair GE Monogram counter depth. Glenn J. • El Cajon , CA • July 27, 2020
This was a very easy repair, the on-line video at AppliancePartsPros.com was helpful.
The Helix was spinning freely (meaning, the Auger Blade was not holding it in place on the Auger).
Pulling the assembly apart was a snap, and very logical (the video is perfect if you get lost).
The family is now enjoying both crushed and cubed ice - and the redesign of the Auger Blade seems to prevent clogging in the ice shoot.
Read more
More
$51.62
- Compare At:
-
$61.43
- You Save:
-
$9.81
Genuine Ge part
By: Ge
Part Number: WR23X427
Freezer light not turning on or off? This door light switch activates interior lighting when opened. Moderate DIY repair—press tab, rotate out old switch.
Do-It-Yourself Stories from Customers like You
Broken light switch. Tommy J. • Yortown , VA • October 16, 2017
Replaced light switch.
Read more
More
$74.95
- Compare At:
-
$88.44
- You Save:
-
$13.49