Kenmore Refrigerator 363.58477894 (36358477894, 363 58477894) Parts

Found that piece of auger was broken up front. Ordered auger and several other parts associated with ice maker just to be sure. Also replaced condenser motor which was making noise. Read more

The ice dispenser door was not closing tightly. As a result, there was frost build up in the ice chute, which also was allowing ambient air and temperature into the freezer compartment. Upon further inspection, there was black “schmutz” on the ice door, and the rubber ice funnel and deflector parts were deteriorating. Because the door was not closing tightly, I also assumed that the door-closing spring was week. The parts I ordered were: ice door assembly, ice funnel, ice deflector, spring and... Read more

4 screws Read more

Replaced it... New part fit perfectly and looks great. Easy fix. Read more

Disassemble, replace, reassemble Read more

I needed to find a parts supplier who could provide a replacement part at a reasonable price. I first tried the manufacturer, General Electric, but they only showed freezer replacement parts for the model of my side-by-side refrigerator. In looking over a list of parts available for this model there seemed to be a possible part that sounded like a match but there was no picture to confirm that this was the correct replacement part. When i clicked the Appliance Parts Pros web site They had a... Read more

I fixed the drip with a bit of silicone. I fixed the rusty parts Auger & End Plate by replacing them. I repaired the dispenser by replacing the defective door. I used the various videos connected with the parts ( including related parts that I did not replace but required removing them first) to learn and confirm how to properly remove and replace the parts. These were incredibly valuable, Thank You! Read more

I removed ice maker, cleared out frozen food to make room for drill, removed broken support, & drilled out old pop rivet (covering the area below with a cloth to catch the metal shavings). Then I carefully straightened the metal support, loosely installed the new support, and pop-riveted it onto the support using the same size rivet. I reinstalled the ice maker, replaced the frozen food, and turned the ice maker back on. No issues. Read more