Kenmore Refrigerator 363.9565412 (3639565412, 363 9565412) Parts

I took the ice bucket out and saw the Plate and the Auger were rusted out I thought about cleaning it but I figured that the rust prevent coating was probability all gone I've had this refrigerator since 98 , so I figured the best way was to buy the replacement parts . the price was pretty good so I went that route , the taking apart was very easy , its the putting back together that takes time , however I took a video of the bucket before I took it apart and the on-line video that... Read more

Ordered the parts and in a couple of days they arrived. A simple Philips screw driver was all that was needed to complete the install. Very simple, not complicated. You don't need to order the slide bushings as the slide assy. has them installed from the factory. Appliance Parts Pros is the best!!! terry,florida Read more

Did some research on Appliance Parts Pros site. Took a chance and ordered the parts I thought were needed. They came in three days. Suspicions confirmed. Relatively easy fix. All went well. Repair videos were especially helpful. Appreciate ease of repair and help from App Parts. Thanks Read more

Swapped it out for new tube. Take 5 minutes and zero effort. The drain tube will clog with mold. You can clean it out but the tube will clog again despite's you best efforts as the tube wall provide a great habitat. Ordered new tubes to facilitate swap-outs. Old tubes can be cleaned but will recolonize quickly. Read more

Ordered parts from appliance parts pros and completed installation myself Read more

Replaced the deflector Read more

Replaced the broken part. Exact fit. 15 minutes. Works perfectly. Read more

I replaced the door stop. Fortunately, I did NOT follow the advice on your Questions and Answers discussion and remove the door to do this: "You will need to remove the door hinge cover and hinge from the top of the door. Then lift and remove the door from the refrigerator. Lay the door on a soft surface and remove the screws holding the door stop WR2X9302 in place. Reinstall in reverse order." The two screws are fairly easy to remove with a socket wrench with the door in place. Read more

Disassemble, replace, reassemble Read more

Determined from the schematic on the inside of the cover of the icemaker that the likely problem was the "stop" micro switch.... Took the whole thing apart and confirmed the switch was defective. Replaced it with a standard DPDT switch - for a temporary fix. Went on line to find replacement. Bought it from APP Parts Pros. replaced DPDT switch with micro.. all is well.... saved at least $150 by not having a repair person come to the house - felling good about this..... Read more