Kenmore Washer Dryer Combo 417.9968020 (4179968020, 417 9968020) Parts

Best Seller

Genuine Frigidaire part

Tub Seal

By: Frigidaire

Part Number: 5303279394

The Tub Seal is an OEM part for Frigidaire washing machines. It is designed to create a water-tight seal between the washing machine tub and the transmission or drive system. This seal prevents water from leaking out during the operation of the washer and protects the mechanical components from water damage.

Symptoms of a failing tub seal include:

Water leaking from the underside of the washing machine.
Increased moisture or puddles forming under the machine during use.
A musty or moldy smell, indicating that water has been seeping and not properly drying.

Causes of a bad tub seal can include aging and wear over time, exposure to harsh detergents that degrade the material of the seal, or mechanical stress from unbalanced loads that can cause the seal to fail. It's important to address these issues promptly to prevent further damage to the washing machine.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This part fixes the following symptoms

Leaking

Do-It-Yourself Stories from Customers like You Noisey bearing on spin cycle Neal G. • Klamath Falls , OR • February 14, 2016

I replaced the spin bearing, tub seal, washer and drive belt since I had it all apart. The video was extremely helpful...I would have tore the whole thing apart trying to figure out how the agitator came off....but it was very simple. Read more

Best Seller

Genuine Frigidaire part

Drain Hose

4.9 (19)

By: Frigidaire

Part Number: 131461200

The Washer Drain Hose is an OEM replacement part for Frigidaire washing machines. It is a flexible, 7 ½ ft plastic hose that connects the washer tub to the household drainage system. The drain hose removes water from the washer at the end of each cycle.

Symptoms of a faulty drain hose include:

Water failing to fully drain or continuously draining
Wet flooring around the washer due to leaks
Excess water left standing in the washer tub after cycles
Reduced washing performance due to inadequate drainage

Causes of a bad drain hose include kinks or bends that restrict water flow, cracks or holes from wear and tear, and blockages from accumulated debris. These issues can compromise the hose's ability to drain water properly.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Do-It-Yourself Stories from Customers like You Leaky drain hose Rocco S. • Rochester , NY • February 24, 2017

Simply open the top of the washer by inserting a putty knife (watch YouTube ) and then the front panel by removing two bottom philips head screws on the front. The whole front panel comes right off. Using pliers the spring clams holding each hose, they come off and each hose is replaced. The drain one was only leaking but since it has open I changed both and even the drive belt. Whole job less than 1 hour. BTW parts arrived next day! Read more

Genuine Frigidaire part

Agitator Hub

5.0 (9)

By: Frigidaire

Part Number: 134418700

The Agitator Hub is an OEM part for Frigidaire washing machines. It connects the agitator to the drive shaft, enabling the agitator to rotate and move clothes effectively during the wash cycle.

Causes of a bad agitator hub can include wear and tear from frequent use, exposure to harsh detergents or hard water, or damage from overloading the washer.

Symptoms of a bad agitator hub include:

Agitator not moving or rotating properly
Loud noises or grinding sounds during the wash cycle
Clothes not being cleaned effectively
The washer shaking or vibrating excessively

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Do-It-Yourself Stories from Customers like You The agitator was not working John H. • Auburn , NY • October 11, 2016

The agitator stopped functioning and there was a squeaking sound occurring in agitation mode. I found that if I cranked down on the agitator cap, screwing in as hard as I could, the agitator would work briefly, then the cap would loosen and agitator stop moving. I removed the agitator cap, along with which came the agitator stud cap and a rubber washer/seal which was jammed up into the underside of the cap. I lifted out the agitator from the drum and inspected it and the hub best I could.... Read more

Genuine Frigidaire part

Idler Pulley

4.8 (31)

By: Frigidaire

Part Number: 131862900

The Idler Pulley is an OEM part for Frigidaire dryers. It helps guide and maintain tension on the dryer drum belt, ensuring the drum rotates smoothly during the drying cycle.

Over time, the idler pulley can wear out due to friction and regular use, or it may become damaged from excessive strain or misalignment. If the idler pulley fails, the dryer drum may not rotate properly, leading to inefficient drying or a complete inability to dry clothes.

Symptoms of a bad Idler Pulley include:

Squeaking or squealing noises during operation
The drum not rotating or rotating unevenly
The belt appearing loose or slipping off the drum

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This part fixes the following symptoms

Burning smell

Do-It-Yourself Stories from Customers like You Noisey bearing on spin cycle Neal G. • Klamath Falls , OR • February 14, 2016

Genuine Frigidaire part

Trunnion (Washer Inner Tub Hub)

4.7 (6)

By: Frigidaire

Part Number: 131545101

The trunnion is the hub that mounts the washer's inner tub to the drive shaft. Replacing a worn hub restores a solid, centered connection so the basket spins smoothly without wobble, slip, or grinding. What it does:

Secures and centers the spin basket on the drive shaft for balanced rotation
Transfers drive torque to the inner tub during spin
Helps maintain basket alignment to reduce vibration
Typical symptoms of failure: loose/wobbly tub, scraping or grinding noises, poor or no spin, frequent out-of-balance events

What's included:

1 trunnion

Install notes:

Disconnect power and water before service; wear gloves and eye protection
Access the hub by removing top/access parts, then the agitator/wash plate and inner-tub fasteners
Clean the shaft and mating surfaces; seat the new trunnion fully and tighten fasteners evenly in a crisscross pattern
Inspect related parts (tub seal, bolts, bearing) while open and replace if worn; run a short test cycle to ensure smooth spin

Do-It-Yourself Stories from Customers like You Leaking washer tub Hugh S. • Miami , FL • June 25, 2016

The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more

Genuine Frigidaire part

Washer Transmission Assembly

4.0 (1)

By: Frigidaire

Part Number: 134736400

Oil leaking from agitator or poor spin performance? This washer transmission assembly restores wash and spin cycles. Advanced repair, 2-3 hours.

Do-It-Yourself Stories from Customers like You Transmission seal leaking oil into washer tub. Michael M. • Shirley , NY • February 18, 2024

Transmission seal was not available so I installed a new transmission. Works well. Thank you! Read more

Genuine Frigidaire part

Thermostat - Heater

5.0 (1)

By: Frigidaire

Part Number: 131658100

Do-It-Yourself Stories from Customers like You Dryer had stopped heating Ron B. • Saint Augustine , FL • June 29, 2018

Replaced the dryer heater, and for good measure the limit and thermostat switches. My whole experience with Appliance Parts Pros was exceptional. I had a few questions to which the pros went out of there way to get the answers I needed. They also sent me the service manual which had step by step illustrations on how to disassemble the dryer. Saved a lot of time. Read more

Genuine Frigidaire part

Bleach Dispenser

5.0 (1)

By: Frigidaire

Part Number: 3204394

Do-It-Yourself Stories from Customers like You Missing bleach dispenser. Jim W. • Ardmore , OK • May 12, 2020

Ordered part. Read more

Genuine Frigidaire part

Agitator (Upper)

5.0 (1)

By: Frigidaire

Part Number: 131427200

This replacement upper agitator restores the washer's normal wash action by moving clothes and improving water circulation for better cleaning. It fits the factory agitator location and replaces worn, cracked, or damaged agitators to restore performance. What it does:

Rotates during the wash cycle to move garments through the water for more effective cleaning
Promotes water flow and prevents clothes from bunching or tangling
Replaces a cracked, broken, or excessively worn agitator that causes poor wash results
Helps reduce unusual noise or vibration caused by a damaged agitator

What's included:

One upper agitator

Install notes:

Disconnect power and water supply before beginning any repair
Remove the agitator cap/cover and securement (bolt or clip) to lift out the old agitator
Install hardware to manufacturer torque recommendations
Run a short test cycle with a small load to check for leaks or vibration

Do-It-Yourself Stories from Customers like You There was a piece missing from it and it chewed up laundered items. Michelle B. • Southampton , NY • August 17, 2020

Replaced the damaged agitator with a new one. After watching the youTube video from this website. Read more

Genuine Frigidaire part

End Cap

5.0 (1)

By: Frigidaire

Part Number: 131288211

White. Right hand side

Do-It-Yourself Stories from Customers like You Washer wouldn't run but as dryer did it obviously wasn't a circuit breaker E James W. • Wilmington , NC • September 29, 2014

First attempt was to replace the door latch mechanism...didn't fix it. Kept researching and the washer control knob had been hard to turn so it seemed logical that was the problem. Also, at some point the end cap had broken. As it has the main grounding point inside it and as I was taking the control panel apart anyway it made sense to replace it. Read more

Genuine Frigidaire part

Transmission Pulley

By: Frigidaire

Part Number: 131498301

Genuine Frigidaire part

Lid Lock Switch Assembly

4.9 (22)

By: Frigidaire

Part Number: 134101800

This washer switch is both the lid lock and lid switch. New mounting bracket replaces older design. Which means in some applications you may need to drill off old design mounting bracket prior to mounting the new lock. If your replacing the 4 wire switch you will need to tape off light switch leads. The light will no longer be used. Instructions included.

Do-It-Yourself Stories from Customers like You My 20 year old frigidaire stackable washer needed the lid switch replaced so it would trigger the spin cycle Maryann S. • Owosso , MI • March 13, 2014

I unplugged the power source to the appliance. I unscrewed 2 screws and unplugged the lid switch. I replaced the old switch with the new switch and screwed in the same 2 screws that held the old switch in place and plugged the new lid switch back in under the lid. that's it . I plugged in the washer and started a load of clothes. works just fine. NO HUGE REPAIR BILL. Gosh it makes me happy to do such a simple repair to my old machine and for a very reasonable part price, my washer is... Read more

Genuine Frigidaire part

Dryer Timer Power Resistor

4.0 (1)

By: Frigidaire

Part Number: 134446800

The dryer timer power resistor regulates electrical current to the timer motor in mechanical timer systems. Replace when the timer fails to advance properly, gets stuck in cycles, or the dryer runs continuously without stopping.

Do-It-Yourself Stories from Customers like You Dryer timer would not advance in automatic dry mode worked fine in timed mode Michael S. • Bear , DE • February 05, 2016

Replaced the power resistor on the timer assembly. Solved the problem. Read more

Genuine Frigidaire part

Washer Wiring Harness Clip

By: Frigidaire

Part Number: 131063700

Secures wiring harness to prevent chafing and maintain safe wire routing in washers, dryers, and laundry appliances. Replace if loose or broken. Check your model for compatibility.