Kenmore Dishwasher 665.13043K110 (66513043K110, 665 13043K110) Parts

This hose clamp secures dishwasher hoses to fittings and ports to maintain a tight, leak-resistant seal. Replacing a worn clamp helps prevent drips and loose connections that can cause water under the unit.

• Secures drain or circulation hose to the pump, sump, or other dishwasher fittings
• Helps maintain a watertight seal at hose connection points
• Can help resolve water dripping from a hose joint or a loose hose
• Replace if corroded, deformed, cracked, or no longer holds tension

• Disconnect power and turn off the water supply before servicing
• Place a towel or shallow pan to catch residual water when removing hoses
• Fully seat the hose on the fitting, position the clamp over the barb/connection, and secure firmly
• After reassembly, run a brief fill/drain and check all connections for leaks

Dishwasher won't start or lights flashing? The electronic control board manages cycles and timing. Moderate DIY repair restores full operation.

Fix intermittent power issues or loose connections in your dishwasher. This wire connector restores secure electrical contact between components.

Filters debris from water to protect pump and spray arms. Replace if you notice slow drainage, poor cleaning, or water left in tub. Verify fit by model.

White toe panel for dishwashers. Covers the base below the door for a finished look. Replace if cracked, discolored, or missing. Easy installation.

Color: Biscuit. Screw for lower toe panel. For black screw use WP302868, for white screw use WP3400836.

Color: White. Size: 1 qt. can. Acrylic appliance paint.

This mounting kit secures your dishwasher's tall tub to the floor, preventing movement and vibration during operation. It replaces worn or missing floor mounting hardware that can cause your dishwasher to rock or shift during wash cycles.

Access panel covers the base of your dishwasher, concealing wiring and mechanisms. Replace if cracked, broken, or missing after installation.

This dishwasher rack repair kit contains touch-up paint to restore damaged or chipped dish rack coating. It prevents rust and maintains the protective finish on wire racks. Use it to repair small chips or worn spots that could snag dishes or spread rust.

Insulated wire lead that carries electrical current between dishwasher components. Replace if wire is frayed, damaged, or missing connection points.

This is the lower front panel that mounts beneath the dishwasher door, concealing the motor, wiring, and plumbing connections underneath the unit. It snaps or screws into place and gives the dishwasher a clean, finished look. Replace this panel if it is damaged, warped, or missing, which can leave internal components exposed to dust and debris.