Kenmore Dishwasher 665.13822K600 (66513822K600, 665 13822K600) Parts

Fix a dishwasher that won't fill properly or overfills with this overflow switch lever. Restores water level detection. DIY-friendly repair.

Replacement wheel leg assembly for dishwashers. Restores mobility and stable support when original leg is cracked, broken, or worn. Snaps into groove.

Fix a broken or missing dishwasher detergent dispenser cover. This shield protects the dispenser assembly and restores a finished look to your unit.

4-24 x 3/8 screw secures trim panels, brackets, and internal components in your dishwasher. Replace if missing, stripped, or corroded during repairs.

Covers and directs dishwasher exhaust while keeping the vent opening protected. Replace if cracked, discolored, or loose. Verify fit with your model number.

This kit includes hose clamps and fasteners used during dishwasher installation to secure the drain hose and water supply connections. It ensures tight, leak-free connections between the dishwasher and household plumbing. Replace this kit if you notice water leaking at hose connections or if clamps are corroded, broken, or missing during a new installation or reinstallation.

This is the exterior-facing panel that forms the visible front surface of the dishwasher door. It provides a finished appearance and helps protect the internal door components, including insulation and wiring. Replace this panel if it is dented, scratched, rusted, or if the finish has deteriorated significantly.

White toe panel that covers the bottom front of your dishwasher. Replace if cracked, discolored, or missing to restore a finished appearance.

Right-hand door hinge that restores proper door alignment and smooth operation. Replace if your dishwasher door sags, binds, or won't stay open. Verify fit.

The Thermostat Clip is an OEM part for Whirlpool dishwashers. It plays an important supporting role by securely fastening the thermostat sensor inside the wash chamber. 

Symptoms of a faulty Thermostat Clip can include:

• Fluctuating or inconsistent water temperatures between cycles 
• Inability to properly detect temperature for desired heat levels
• Longer cycle times needed for reaching required temperatures
• Strange sounds or condensation around thermostat connection

Causes could arise from typical wear and tear stresses weakening plastic retaining clips. Exposure to harsh detergents may also erode clip material integrity over time.

This OEM replacement part is compatible with KitchenAid, Jenn-Air, Kenmore, and select Hotpoint and Roper dishwasher models as well. 

Access panel covers the base of your dishwasher, concealing wiring and mechanisms. Replace if cracked, broken, or missing after installation.

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

This is a small plastic or rubber fitting that secures the power cord where it enters the dishwasher's junction box or base. It prevents the electrical wiring from being pulled, kinked, or damaged by absorbing tension on the cord. Replace this part if it is cracked or missing, which can leave wiring exposed and vulnerable to damage during installation or use.

Fix water leaking from under your dishwasher with this pump volute. Directs water flow and prevents leaks with integrated seal. 20-minute repair.