Kenmore Range 790.45792100 (79045792100, 790 45792100) Parts

Opened oven door to the fully opened position. Pulled up the the lock located on both hinge supports and engaged it in the hook of the hinge levers. You may need to apply a little downward pressure on the door to pull the locks fully over the hooks. In addition, you may need to use a flat head screwdriver to "help" engage the hinge locks over the hook. Hold the door securely on both sides (not the door handle). Pulled the bottom of the door up and toward me to disengage the hinge supports.... Read more

After failing to Humpty Dumpty back together again I replaced the part. I am not particularly handy but it went smoothly Read more

It was a little tricky. I watched a video it helped a little . Took the door apart, that was the easy part, BUT putting it back, could not remember sequence of parts. I would suggest take a picture of each piece as you remove them that would help. Read more

Followed the video that was on the site. Almost as easy, except mine didn't have a terminal block, just individual lugs. The lugs were a little tight, guess so as they have been on for over 17 years. Took one off at a time and put it on the new switch. With needed floor cleaning, the task only took about 20 minutes. I selected basic delivery and it took almost 10 days. They could have shipped it USPS for faster service, as it only weighed 1/2 lb. Read more

Replaced the Controller (mother board). I previously replaced the temperature probe (316217002) but that did not resolve the problem. Replacing the Controller (318185446 / AP3583606) was much easier and quicker than replacing the probe. Simply remove the 6 or 8 screws that secure that range top and the top lifts easily exposing the Controller. There are only 4 electrical connections that easily unplug and reattach. Although the new board has more connection points, they are similarly labeled... Read more

Ordered a new clock/timer control. This was very easy to install the real trick was removing about 8 wires and 4 plug in connectors from the board and then reinstalling them back in the same location as the were before. I took a photo of the board with my IPhone before taking all the wires off, this made it very easy to reinstall the wires on the same terminals as before. There are 2 additional connectors on the board that a flat ribbon cable from the touch button panel attaches to. Do not just... Read more

Replaced both door hinge receptacles Read more