Kenmore Range 790.46899902 (79046899902, 790 46899902) Parts

This control-panel switch restores reliable on/off control of a selected function on your range or wall oven. Replacing a worn or intermittent switch helps ensure the appliance responds consistently when you toggle that function.

• Directs power to the associated circuit when switched on or off
• Common symptoms: function won't turn on/off, intermittent operation, or the switch feels loose/sticks
• Helps restore positive, consistent control from the backguard/control panel

• Disconnect power at the breaker before servicing
• Access the switch from the control panel/backguard; retain screws/clips
• Label/photograph wire positions and transfer leads one at a time to the new switch
• Ensure firm terminal connections, reassemble, restore power, and test operation

Seals your oven door to retain heat and maintain consistent cooking temperatures. Replace when worn, cracked, or after self-clean cycles. Verify fit.

This is a relay control board that manages power delivery to the surface burners on an electric range, including simmer functions. It receives signals from the burner knobs or touch controls and switches the heating elements on and off to maintain the selected temperature. Replace this board if surface burners fail to heat, won't maintain a simmer setting, cycle erratically, or if you receive error codes related to the cooktop elements.

Oven not reaching temperature or cooking unevenly? A faulty bake element is often the cause. This heating element restores proper baking performance.

This is a black rubber gasket that seals the area between the control panel and the range body, preventing heat, grease, and moisture from reaching the internal wiring and controls. It helps protect sensitive electronic components from damage caused by exposure to cooking heat and spills. Replace this gasket if it is cracked, brittle, missing, or if you notice heat or moisture getting behind the control panel.

Screw that adjusts and secures the leveling leg to your range base or bracket. Replace if stripped, bent, or missing to restore stable footing and level your appliance.

This is the cooling fan motor that draws air across the oven cavity and control panel area to prevent overheating of surrounding cabinetry and electronic components. It typically runs during and after oven use to dissipate heat. Replace this motor if the oven shuts off unexpectedly due to overheating, the cooling fan does not spin, or you notice excessive heat around the control panel or cabinet surfaces near the range.

Replace a cracked, broken, or missing oven door spacer that maintains proper alignment and gap between door components. Installs in door assembly.

Heat-resistant insulation that wraps the oven cavity to contain heat. Replace if worn, damaged, or missing to improve heat retention and efficiency.

Spacer that maintains proper gap between components in your range or oven assembly. Replace if missing, worn, or damaged to restore correct fit and alignment.

Oven won't maintain temperature or exterior gets too hot? This insulation blanket contains heat and protects nearby components. Moderate DIY repair.

This is a normally open cooling fan thermostat that activates the oven's cooling fan when internal temperatures reach a set threshold. It helps regulate airflow to protect surrounding cabinetry and electronic controls from excessive heat. Replace this thermostat if the cooling fan fails to turn on during or after oven use, or if the fan runs continuously without shutting off.

Replacement control knob for your range or cooktop. Installs on the valve stem to select burner heat levels. Replace cracked, loose, or stripped knobs.

Replacement mounting screw that secures panels, trim, and components in ranges and ovens. Needed when original screws are lost, stripped, or damaged.

Fastens panels, brackets, and covers inside your range or oven. Replace this screw if missing, stripped, or rusted to secure components properly.

Burner won't heat or stays on high? This cooktop infinite switch controls element temperature settings. Moderate DIY repair taking 30-45 minutes.