Kenmore Range 790.72319011 (79072319011, 790 72319011) Parts

Replace your range oven door hinge pin rod if cracked, bent, or missing. This structural rod keeps the door aligned and securely attached to the hinge.

Maintop bracket secures the cooktop surface to the range frame. Replace if cracked, bent, or broken to restore proper alignment and support.

Replacement shield that protects internal range components from damage. Install this cover if your original is cracked, broken, or missing to keep panels secure.

This is the broil burner tube located at the top of the oven cavity in a gas range. It produces the high, direct heat used for broiling foods. Replace this burner if the broil function fails to ignite, heats unevenly, or produces weak or irregular flames.

Replacement wire harness for ranges. Connects control board to components. Install when original harness is damaged, wires are frayed, or connectors worn.

Secures components inside your range. Replace if broken, loose, or missing to prevent rattling and ensure proper part alignment. Verify fit with your model.

Insulation panel installs inside the range cabinet to provide thermal barrier and sound dampening. Replace if cracked, worn, or missing for proper fit.

Burner tube for gas ranges. Connects gas valve to burner assembly. Replace if cracked, corroded, or leaking to restore proper gas flow to cooktop burners.

Protective cover that shields the range door hinge assembly from debris and damage. Replace if cracked, broken, or missing to restore a clean finished look.

A replacement motor latch that secures the motor assembly to the appliance chassis, helping keep the motor stable during operation for smoother performance and reduced vibration. Fits specific Frigidaire/WCI motor assemblies. What it does:

• Secures and positions the motor assembly to prevent excessive movement
• Helps reduce vibration and rattling caused by a loose motor mount
• Restores proper alignment between motor and drive components
• Can eliminate intermittent contact-related noise from a shifting motor

• Disconnect power (unplug or switch off breaker) before starting any repair
• Installation typically requires accessing the motor area—expect to remove panels or the cabinet
• Keep track of mounting hardware; replace any damaged fasteners
• Test operation after reassembly; stop and recheck if noises or vibration persist

Decorative trim kit that restores the finished look of your range door. Replaces cracked, chipped, or missing trim pieces and covers exposed door edges.

Insulates the oven cavity to reduce heat transfer and improve energy efficiency. Replace if damaged, compressed, or missing to restore proper insulation.

Mounting bracket that secures the gas pressure regulator to your range frame. Replace if bent, broken, or missing to properly support the regulator assembly.

This is the inner liner panel of the oven door, typically made of porcelain-coated steel or similar heat-resistant material. It sits behind the door glass and helps insulate the oven cavity, reflecting heat back inside for efficient cooking. Replace this liner if it is cracked, chipped, rusted, or if you notice heat escaping from the oven door during use.