Kenmore Range 790.7965370A (7907965370A, 790 7965370A) Parts
Genuine Frigidaire part
By: Frigidaire
Part Number: 316540900
The Screw is an OEM part for Frigidaire ranges and cooktops. This part secures the burner head in place, ensuring proper alignment and functioning of the burner.
Causes of a bad burner head screw can include loosening due to repeated heating and cooling cycles, damage from impact or mishandling, or simply wear and tear over time.
Symptoms of a loose or missing burner head screw include:
- Uneven or irregular flame pattern on the burner
- Burner head not sitting flush or properly aligned
- Burner head wobbling or moving during use
- Potential gas leaks if the burner head is not securely fastened
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Ignitor failed / screw that attached burner to ignitor stripped Michael M. • Roundhill , VA • May 17, 2015
Ordered new Ignitor / Orifice and screws
Mike was a great resource, he helped me thru the project.
Read more
More
$19.95
- Compare At:
-
$23.74
- You Save:
-
$3.79
Genuine Frigidaire part
By: Frigidaire
Part Number: 316116400
Oven light not working or saw a flash near the bulb? This light socket houses the oven bulb and is a straightforward DIY fix in under 30 minutes.
Do-It-Yourself Stories from Customers like You
Light socket inside oven broke Linda S. • Novato , CA • June 02, 2015
Had to pull double oven and range top out from wall which involved removing the upper kitchen cabinet. Took the sheet metal off the back and had the socket swapped out in a couple of minutes. My old oven works like a charm!
Read more
More
$55.30
- Compare At:
-
$65.25
- You Save:
-
$9.95
Genuine Frigidaire part
By: Frigidaire
Part Number: 316527500
Burner orifice for gas ranges and cooktops. Controls gas flow to burner. Replace if cracked, corroded, or when converting between natural gas and propane.
Do-It-Yourself Stories from Customers like You
The orafices were set up for propane and i needed them for nutural gas Arnold M. • Belen , NM • December 14, 2015
Found the parts I needed ordered them from your site
Received them and installed in a few minuets and was done
Read more
More
$30.95
- Compare At:
-
$36.83
- You Save:
-
$5.88
Genuine Frigidaire part
By: Frigidaire
Part Number: 316558300
Replacement gas burner for ranges and cooktops. Restores even flame distribution when original is clogged, damaged, or worn from boilovers and daily use.
Do-It-Yourself Stories from Customers like You
Burner would not light i cleaned and cleaned and cleaned it Kathleen N. • Mapleton , UT • July 31, 2016
Replaced the part and it works great. Thanks!
Read more
More
$54.25
- Compare At:
-
$64.02
- You Save:
-
$9.77
Genuine Frigidaire part
By: Frigidaire
Part Number: 316527504
Burner orifice controls gas and air flow to cooktop burners. Replace if cracked, corroded, or when converting between natural gas and propane fuel types.
Do-It-Yourself Stories from Customers like You
The orafices were set up for propane and i needed them for nutural gas Arnold M. • Belen , NM • December 14, 2015
Found the parts I needed ordered them from your site
Received them and installed in a few minuets and was done
Read more
More
$32.95
- Compare At:
-
$39.21
- You Save:
-
$6.26
Genuine Frigidaire part
By: Frigidaire
Part Number: 316404901
Burner won't light or flame is weak? This gas valve controls flow to your range surface burner for reliable ignition and heat control. Moderate DIY.
Do-It-Yourself Stories from Customers like You
Leak detected in my original valve John T. • Warren Center , PA • December 24, 2016
Replaced the old valve with a new one from AppliancePartsPros.com. I watched one of the YouTube videos to get an idea of what the process would entail. I gathered the tools I would require, plus a work light. The repair/replacement went pretty good. One thing the video I watched didn't cover was adjusting the valve for a propane system. I compared my old valve to the new one and saw that I would have to screw down the oven gas outlet until it "bottomed out".
Read more
More
$230.95
- Compare At:
-
$277.14
- You Save:
-
$46.19
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304509869
Leveling leg assembly installs at the front corners of your range. Replace if broken, rusted, missing, or no longer adjusts to level your appliance.
Do-It-Yourself Stories from Customers like You
I got a good deal on a used stove and noticed it was missing the front leveler foot Clifford H. • Anacortes , WA • September 21, 2014
I ordered one of these and used two extra screws I had lying around and now I have a nice level stove! Thanks AppliancePartsPros.com!
Read more
More
$13.95
- Compare At:
-
$16.74
- You Save:
-
$2.79
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304498835
Replace your range oven door gasket to prevent heat escape and maintain proper temperature. Snaps into place with embedded clips. Confirm fit by model.
Do-It-Yourself Stories from Customers like You
Was brok seal gasket and too old Ang T. • Garden Grove , CA • May 22, 2015
Easy just pull clip and put back
Read more
More
$80.95
- Compare At:
-
$96.33
- You Save:
-
$15.38
Genuine Frigidaire part
By: Frigidaire
Part Number: 316536610
This surface burner ignitor/orifice assembly directs gas through a calibrated orifice and provides the spark to ignite it. Replacing a worn or damaged assembly restores consistent lighting and an even flame on the affected rangetop burner.
- Routes gas from the valve through the orifice to the burner head
- Positions the ignitor for reliable sparking and quick ignition
- Helps maintain correct flame size and pattern on that burner
- Common symptoms: burner won't light, clicks without flame, delayed ignition, weak or uneven flame
What's included: One ignitor/orifice assembly. Install notes:
- Disconnect power and shut off the gas supply before servicing
- Remove grates, caps, and burner heads; lift the cooktop to access the assemblies
- Note wire routing and original orifice location; transfer any reusable hardware from the old part
- After installation, restore gas and check connections for leaks, then test spark and flame
Also known as: Orifice holder with ignitor; surface burner igniter/orifice assembly.
Do-It-Yourself Stories from Customers like You
No flame at rear burner. Chris M. • Gladstone , NJ • February 03, 2023
I replaced the Ignitor/Orifice Tube assembly.
Read more
More
$81.95
- Compare At:
-
$98.34
- You Save:
-
$16.39
Genuine Frigidaire part
By: Frigidaire
Part Number: 316527511
Burner orifice regulates gas flow to your range burners. Replace if clogged with debris, corroded, or damaged to restore proper combustion and heat output.
Do-It-Yourself Stories from Customers like You
The orafices were set up for propane and i needed them for nutural gas Arnold M. • Belen , NM • December 14, 2015
Found the parts I needed ordered them from your site
Received them and installed in a few minuets and was done
Read more
More
$28.95
- Compare At:
-
$34.45
- You Save:
-
$5.50
Genuine Frigidaire part
By: Frigidaire
Part Number: 316438200
Replacement burner head for gas ranges and cooktops. Mounts over the orifice to distribute flame evenly. Needed when original is cracked or damaged.
More
$58.43
- Compare At:
-
$69.53
- You Save:
-
$11.10
Genuine Frigidaire part
By: Frigidaire
Part Number: 316112005
Anti-tip bracket kit secures your range to the floor or wall, preventing tipping when the oven door is opened or heavy cookware is placed on extended racks.
Do-It-Yourself Stories from Customers like You
Missing anti tip bracket. Chip M. • Coconut Creek , FL • June 08, 2019
Installed the new bracket as per instructions with template enclosed and it was perfect.
Read more
More
$17.95
- Compare At:
-
$21.36
- You Save:
-
$3.41
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304508510
Burner cap sits atop the gas burner base to distribute flame evenly. Replace if cracked, warped, discolored, or missing to restore proper heat distribution.
Do-It-Yourself Stories from Customers like You
The little plates were missing from the burners Cita M. • San Angelo , TX • June 10, 2018
Found web site. Called the 800 number. Placed the order. 2 days later, they were at my door.
Read more
More
$44.24
- Compare At:
-
$52.20
- You Save:
-
$7.96
Genuine Frigidaire part
By: Frigidaire
Part Number: 316438600
Replacement surface burner head for gas ranges and cooktops. Distributes gas through precision ports for even flame. Needed when original is clogged, damaged, or corroded.
Do-It-Yourself Stories from Customers like You
Yellow flame coming out on the right side of the burner right front burner John J. • Petal , MS • January 22, 2021
Conversion kit said put propane orifice .109 in to correct the problem but I had to use the .102 orifice.
Read more
More
$65.74
- Compare At:
-
$78.89
- You Save:
-
$13.15
Genuine Frigidaire part
By: Frigidaire
Part Number: 316536614
The Igniter and Orifice Assembly is an OEM part for Frigidaire ranges. This part ignites the gas burners and regulates the flow of gas through the orifices.
Causes of a bad Igniter and Orifice Assembly can range from electrical issues or corrosion affecting the igniter to clogs or obstructions in the gas orifices.
Symptoms of a faulty Igniter and Orifice Assembly include:
- Difficulty igniting or relighting burners
- Uneven or inconsistent flame patterns
- Burners not staying lit or extinguishing spontaneously
- Clicking or sparking noises during ignition attempts
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Front burner electrodes would not ignite the burners Joel D. • O Brien , OR • August 05, 2018
Ordered and replaced the front burner electrodes and orifices. I had to swap out the orifices because the new ones came with natural gas orifices and my stove uses propane.
Read more
More
$79.95
- Compare At:
-
$95.94
- You Save:
-
$15.99
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304508926
Burner won't turn off or element light stays on? This range burner control switch regulates temperature and power. Moderate DIY repair, 30-60 minutes.
Do-It-Yourself Stories from Customers like You
The control knob was orginal equipment but the switch installed by a sears tech was not and the knob eventually would not work the switch Kevin W. • Yucca Valley , CA • December 19, 2016
I went on your website found the parts needed to make the repairs. I watched the short video on installation. The parts arrived just a few days after I placed the order. I finished the repair in less than an hour and had to wait a few minutes to test the switch since the power was off and on due to a wind storm. Simple easy to do repair and I saved $90.00 on service fee for a tech to do the repair.
Read more
More
$64.70
- Compare At:
-
$76.35
- You Save:
-
$11.65