Kenmore Range 790.96222406 (79096222406, 790 96222406) Parts
Genuine Frigidaire part
By: Frigidaire
Part Number: 316443601
The Wall Oven Handle is an OEM part for Frigidaire ovens. It serves as the primary means of opening and closing the oven door, providing a secure grip and easy access to the interior cavity.
A faulty or damaged oven handle can make it difficult or even dangerous to operate the appliance. Causes of a bad handle can include excessive force or strain during opening and closing, exposure to high temperatures that can weaken or warp the material, or simply wear and tear over time.
Symptoms of a faulty Wall Oven Handle include:
- Difficulty opening or closing the oven door smoothly
- Loose or wobbly handle that feels unstable when gripped
- Cracks, chips, or other visible damage to the handle material
- Sharp edges or rough surfaces that can cause discomfort or injury
This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore wall oven models.
Do-It-Yourself Stories from Customers like You
Screws stripped out in handle Thom P. • Palm Coast , FL • October 17, 2016
Replaced with new part
Read more
More
$92.54
- Compare At:
-
$109.20
- You Save:
-
$16.66
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304458312
Replace your cracked, broken, or worn oven door handle. This black handle installs on the exterior oven door with screws. Includes mounting hardware.
Do-It-Yourself Stories from Customers like You
Screws that hold the handle for the oven door stripped out needed a new handle Kevin J. • Maple Plain , MN • August 08, 2015
I used the new screws; which were about 1/4 inch longer then OEM for better engagement, and with Phillips screw driver attached the handle.
Read more
More
$79.43
- Compare At:
-
$93.73
- You Save:
-
$14.30
Genuine Frigidaire part
By: Frigidaire
Part Number: 316116400
Oven light not working or saw a flash near the bulb? This light socket houses the oven bulb and is a straightforward DIY fix in under 30 minutes.
Do-It-Yourself Stories from Customers like You
Light socket inside oven broke Linda S. • Novato , CA • June 02, 2015
Had to pull double oven and range top out from wall which involved removing the upper kitchen cabinet. Took the sheet metal off the back and had the socket swapped out in a couple of minutes. My old oven works like a charm!
Read more
More
$55.30
- Compare At:
-
$65.25
- You Save:
-
$9.95
Genuine Frigidaire part
By: Frigidaire
Part Number: 316405000
Replace your electric range oven door seal when compressed, frayed, or heat escapes. Maintains temperature for efficient cooking. Verify fit by model.
Do-It-Yourself Stories from Customers like You
Too much heat escaping the door Michael K. • Mechanicsville , VA • June 22, 2016
Removing was easy. Pull out the ends of the seal, the ends aren't locked in. Then, pull up on each retaining clip. Each clip is held in with spring tension.
Reinstallation was easy too. Start on one end, Twist frayed end into cone-like shape and insert into one of the holes for the seal. Push in with a skewer/screwdriver. Insert first clip into the first hole. Go around in a linear fashion, inserting each clip into each hole. After the last clip is pushed in, twist the end of the frayed end...
Read more
More
$103.51
- Compare At:
-
$132.23
- You Save:
-
$28.72
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304509869
Leveling leg assembly installs at the front corners of your range. Replace if broken, rusted, missing, or no longer adjusts to level your appliance.
Do-It-Yourself Stories from Customers like You
I got a good deal on a used stove and noticed it was missing the front leveler foot Clifford H. • Anacortes , WA • September 21, 2014
I ordered one of these and used two extra screws I had lying around and now I have a nice level stove! Thanks AppliancePartsPros.com!
Read more
More
$13.95
- Compare At:
-
$16.74
- You Save:
-
$2.79
Genuine Frigidaire part
By: Frigidaire
Part Number: 316575501
Black trim cap that covers the door handle mounting area on ranges. Replace if cracked, broken, or discolored. Installs with screws behind the handle.
Do-It-Yourself Stories from Customers like You
I broke the front of the glass on a range Mary B. • Sulphur Springs , TX • April 18, 2017
I had to order the glass, frame, and cap that the handle attaches to. I just had to put in about 6 screws, it was very simple.
Read more
More
$76.27
- Compare At:
-
$90.76
- You Save:
-
$14.49
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304527842
The Switch Rocker is an OEM part for Frigidaire ranges. This switch is used to control various functions of the range, such as turning on heating elements or activating specific cooking modes. It provides a reliable and straightforward interface for managing the range's features.
You should replace the range switch rocker if it becomes faulty. Causes of a bad switch rocker can include wear and tear from frequent use, exposure to high temperatures, electrical malfunctions, or physical damage from impacts or mishandling. A defective switch rocker can result in unresponsive controls, making it challenging to operate the range effectively.
Symptoms of a bad Range Switch Rocker include:
- The switch not responding when pressed
- Inconsistent or flickering performance of the heating elements
- Physical damage or looseness in the switch
- Intermittent operation or complete failure to activate the desired function
This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.
Do-It-Yourself Stories from Customers like You
The rocker switch for to adjust the size of the heating element for the stove broke as well as the rocker switch to adjust the oven light broke Benjamin G. • West Sacramento , CA • January 07, 2017
I purchased 2 new light rocker switches, Because the heating element rocker switch was unavailable. First I removed the power source for safety. Then I simply pulled each switch out individually with a flathead screwdriver for leverage. I simply unplugged the wires from the old rocker switch, discarded the old rocker, plugged the wires into the new rocker switch, and pushed the new switch appropriately back into the control panel. I used the same steps for both rocker switches. Once...
Read more
More
$15.50
- Compare At:
-
$18.60
- You Save:
-
$3.10
Genuine Frigidaire part
By: Frigidaire
Part Number: 316575500
Frames your range's ventilation opening. Replace if cracked, discolored, or missing. Installs around vent area for a finished appearance.
Do-It-Yourself Stories from Customers like You
Kenmore oven plastic on door melted during cleaning cycle oven bottom cracked enamel Anna G. • Lake Zurich , IL • January 18, 2016
Had to order new plastic panel, scared to run the clean cycle again.
Read more
More
$81.41
- Compare At:
-
$97.69
- You Save:
-
$16.28
Genuine Frigidaire part
By: Frigidaire
Part Number: 5303935377
Replaces cracked, broken, or missing trim on your range door. Restores a finished look, holds glass in place, and eliminates gaps around the door edge.
Do-It-Yourself Stories from Customers like You
I broke the front of the glass on a range Mary B. • Sulphur Springs , TX • April 18, 2017
I had to order the glass, frame, and cap that the handle attaches to. I just had to put in about 6 screws, it was very simple.
Read more
More
$50.57
- Compare At:
-
$59.67
- You Save:
-
$9.10
Genuine Frigidaire part
By: Frigidaire
Part Number: 316112005
Anti-tip bracket kit secures your range to the floor or wall, preventing tipping when the oven door is opened or heavy cookware is placed on extended racks.
Do-It-Yourself Stories from Customers like You
Missing anti tip bracket. Chip M. • Coconut Creek , FL • June 08, 2019
Installed the new bracket as per instructions with template enclosed and it was perfect.
Read more
More
$17.95
- Compare At:
-
$21.36
- You Save:
-
$3.41
Genuine Frigidaire part
By: Frigidaire
Part Number: 5303935318
Restores the finished look around your range door perimeter. Replaces cracked, discolored, or rusted trim that frames the door and secures outer components.
Do-It-Yourself Stories from Customers like You
Oven door never closed tight (11 years) door cap discolored from heat metal trim rusted from spilled grease Bruce G. • Poughkeepsie , NY • March 12, 2016
I replaced the faulty and damaged parts.
Most of the time required was spent cleaning oven grease off of the door parts.
The only hard part was removing the rusted door trim which was stuck to the glass front panel.
Read more
More
$68.95
- Compare At:
-
$82.74
- You Save:
-
$13.79
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304508926
Burner won't turn off or element light stays on? This range burner control switch regulates temperature and power. Moderate DIY repair, 30-60 minutes.
Do-It-Yourself Stories from Customers like You
The control knob was orginal equipment but the switch installed by a sears tech was not and the knob eventually would not work the switch Kevin W. • Yucca Valley , CA • December 19, 2016
I went on your website found the parts needed to make the repairs. I watched the short video on installation. The parts arrived just a few days after I placed the order. I finished the repair in less than an hour and had to wait a few minutes to test the switch since the power was off and on due to a wind storm. Simple easy to do repair and I saved $90.00 on service fee for a tech to do the repair.
Read more
More
$64.70
- Compare At:
-
$76.35
- You Save:
-
$11.65
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304527841
The Rocker Switch is an OEM part for Frigidaire ranges and ovens. It is responsible for turning the interior oven light on and off. The light switch allows visibility of the oven cavity for viewing food during the cooking process.
Causes can include normal wear and tear over time, exposure to heat inside the oven cavity, or accidental damage.
Symptoms of a bad oven light rocker switch include:
- The oven light failing to illuminate when the door is opened
- The light remaining on even when the door is closed
- An inconsistent or flickering oven light
- The switch itself becoming loose, cracked, or non-responsive
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Do-It-Yourself Stories from Customers like You
1 of the 4 burners would not ignite with its own control Shane W. • Fullerton , CA • November 15, 2022
Removed & replaced igniter switch assembly. The hardest part was figuring out how to remove the range top...look up a YouTube video with your manufacturer and model number to see how to do it.
Read more
More
$15.50
- Compare At:
-
$18.45
- You Save:
-
$2.95
Genuine Frigidaire part
By: Frigidaire
Part Number: 316008401
Size: 3/4 inch od x 1/4 inch id.
Do-It-Yourself Stories from Customers like You
Replaced screws on oven handle and door Jason D. • Bowling Green , KY • February 14, 2016
Secured the inner and outer door together and screwed handle back in place.
Read more
More
$8.56
- Compare At:
-
$10.19
- You Save:
-
$1.63
Genuine Frigidaire part
By: Frigidaire
Part Number: 5303935238
If your range has no power or burnt plastic smell, the terminal block may be melted. This kit restores secure power connections. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Terminal block had melted due to loose connections Brandon P. • Durant , OK • June 29, 2014
Replaced the terminal block.
Read more
More
$74.74
- Compare At:
-
$89.69
- You Save:
-
$14.95
Genuine Frigidaire part
By: Frigidaire
Part Number: 5303288565
This truss-head machine screw secures a switch to its mounting bracket or panel. Replacing a worn or missing screw restores a solid, aligned switch fit for reliable operation.
- Fastens the switch body to a bracket or chassis panel
- Helps keep the switch aligned for consistent actuation
- Replaces stripped, corroded, or missing mounting hardware
- Common symptoms: loose or wobbly switch, misalignment, rattling or vibration around the switch area
What's included: 1 truss-head machine screw (#8-32 x 3/16) Install notes:
- Disconnect power to the appliance before servicing
- Start threads by hand to avoid cross-threading; tighten snugly without overtightening
- Verify thread size and length match the original hardware
- If multiple screws secure the switch, replace them in a consistent pattern to maintain alignment
Do-It-Yourself Stories from Customers like You
My ceramic surface cooktop had a large burner that would stick in the full on setting regardless of the control position Hugh H. • Duluth , GA • August 01, 2016
I replaced the Switch for the burner. Works fine.
Read more
More
$7.48
- Compare At:
-
$12.93
- You Save:
-
$5.45