We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Microwave won't heat but runs normally? A failed magnetron is the likely cause. This part generates the microwaves that cook food. Moderate DIY repair.
My son told me that almost all the microwave ovens that came into the repair center he worked at, 15 years ago, had a defective magnetron. I ordered a magnetron, and sat back until one shipped. The one that came, the first time, was in a small factory cardboard box, which was in a large bubble-pak Fedex envelope; which didn't show any signs of abuse. Inside, however, the factory box was beat up. Removing the magnetron, I noticed that the socket, as well as its' pins, was bent, and loose in the... Read more
Most orders arrive by Tuesday, November 24
Microwave not heating or making loud buzzing noise? The high voltage diode regulates power to the magnetron. DIY repair typically takes 30-45 minutes.
LG Help-line said probably a failed magnetron, but since out of warranty,referred me to an authorized LG repair service. They wanted $79.95 service call to come out & diagnose problem. I ordered replacement magnetron for less than cost of a service call, Plus the part was delivered next day! Works like new again. Happy wife = happy life! Notes for DYI-ers: 1.Be careful removing over the stove microwaves--get help,they are heavier than you think. 2.Unplug microwave for 48 hrs, carefully... Read more
Turntable stopped turning or making noise? This microwave motor rotates the glass tray for even heating. Easy DIY fix with basic tools in under an hour.
I googled the make and model, and found the part on AppliancePartsPros.com. The underside of the oven has a metal grille with numerous openings of various shapes and sizes. There is a rectangle that is punched into this grille, just below the motor. I pried between the vent holes to snap the connections near the perimeter on the punched rectangle. I only did this on three sides. Then pry up the rectangle away from the connected side. Undid the hold down screw, separated the motor from the... Read more
The tray was an easy fix as I looked up Kenmore Microwave and ordered the replacement. The light bulb was a little trickier as to replace it you must have a special screwdriver that has a 5-pointed bit with a hole in the middle. This is because nothing else is safely serviceable on the microwave. I unplugged the microwave and moved it to my kitchen table to do the work. The entire outside case had to be removed to access the light bulb which is on the upper right side. You must unplug the... Read more
Color: brown. Each prong measures about 5 inches from the center.
Very easy repair, conveniently there is a hatch on the bottom of my microwave that provides access to the turntable motor. You have to cut this hatch out of the bottom with a pair of wire cutters. Then you just remove the plug on the motor, the two screws and it will come right out. To reinstall the hatch you just rotate it 180 degrees and insert the two tabs into the slots on the bottom cover. You will need one small sheet metal screw to hold it down. It would have been nice if the... Read more