Samsung Washer WF448AAPXAA Parts

• Leaks water

Replaced hose. Read more

• Won't start

First I checked the breaker and outlet and both were good...then I unplugged the machine, took the top off, and removed the control panel. I check the wiring to see if there were any loose plug ins, etc...This is where I figured the panel was bad (or possibly the power cord) so I ordered both. The parts arrived the next day. (incredibly fast shipping) Since I wasn't expecting them til after the weekend I left everything disassembled and went on a mini vacation for a couple of days. Upon... Read more

Replaced drum bearings. Replaced front shocks, one had hardly any resistance. Replace both door boot clamps. Always take pictures as you take apart ! Learned the hard way years ago ! Read more

I watched the Appliance Parts Pros video on YouTube. It showed me how to access and check the suspected parts. I inspected the parts and found arcing on the connection between the stator and position sensor. I ordered the parts at Appliance Parts Pros. When they arrived, I installed and checked out the washer. It was good to go. Thanks for the informative video and easy ordering experience! Read more

Normally, I hire someone to come fix washer or dryer problems as time is limited and if the cost is close or more than the machine, I buy a new one instead. But since we are on shelter-in-place, I figure I could repair it since I have more time on my hands and my brother assured me, it was not hard to do. I took the top panel, door off and then looked online to find a service manual, which allowed me to take the front panel off. My suspected drain hose was the failure mode: the rubber tube... Read more

Put in new assy flange and new spider bolts. New bearing flange and tub seal.It did take a lot of work. The flange was in a lot of pieces and mush, it was a mess. Read more

• Shakes and moves

The front legs were slightly worn and the rubber coverings were missing from the rear feet. This allowed the washer to slide easily on the tile floor. I replaced all four feet. This only required a 12 mm open end wrench. After leveling the washer, things were improved, but I also took the opportunity to replace the four shock absorbers under the drum. The shock absorbers were 5+ years old and one was showing signs of wear / damage. This required removing the front and rear panels with a... Read more

• Shakes and moves

The front legs were slightly worn and the rubber coverings were missing from the rear feet. This allowed the washer to slide easily on the tile floor. I replaced all four feet. This only required a 12 mm open end wrench. After leveling the washer, things were improved, but I also took the opportunity to replace the four shock absorbers under the drum. The shock absorbers were 5+ years old and one was showing signs of wear / damage. This required removing the front and rear panels with a... Read more

Difficult job. Required the complete washer to be taken apart.. With the help of your videos and youtubes was able to get through it. Cleaned everything inside and out. Attached the flange shaft assembly to the inner stainless steel tub via the spider bolts and basically worked backwards from the disassembly. Took a long time total of about eight hours for the whole process not including the cleaning. But it saved me about $600 dollars. Read more