Whirlpool Dryer 3LEH5700N1 Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: 341241
Get your dryer spinning smoothly again - install the Whirlpool 341241 OEM Drum Belt in minutes.
Why this belt?
- Exact factory spec: 92 ¼-inch length × ¼-inch width, 4 ribs / 3 grooves - built to Whirlpool standards, not a generic copy.
- Broad compatibility: Fits most Whirlpool-made dryers - Kenmore 110-series, Roper, Estate, Maytag, KitchenAid, Admiral, Crosley, Amana & more.
- Quiet, durable rubber: Reinforced EPDM resists cracking and stretch for years of reliable tumbling.
Fixes these common dryer problems
| Problem |
How the belt solves it |
| Drum won’t turn |
Transfers motor rotation to drum |
| Loud squealing / thumping |
Replaces stretched or frayed belt |
| Burning-rubber smell |
New belt stops slippage & heat build-up |
| Damp clothes / long cycles |
Restores correct drum speed & airflow |
DIY install — about 15 minutes
- Unplug dryer; remove lint screen housing & front panel.
- Release belt tension at idler pulley; lift drum slightly to slide old belt off.
- Loop new belt around drum, idler pulley and motor pulley (ribbed side down).
- Re-assemble, run test cycle - enjoy quiet, consistent tumbling.
This part fixes the following symptoms
-
Heat stays on after drum has stopped
-
Will not tumble
-
Touchpad does not respond
-
No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You
Broken dryer belt Bob B. • St Louis , MO • September 12, 2015
Unpluged dryer first. Then took the lint filter out and removed the two philips screws inside the lint filter lid. Then take a paint scraper just under the top of the dryer two inches from the left front corner and pushed in a little to release the snap connector and did the same on the right side. Then lifted top over. Then take a 5/16 socket or nut driver and remove the two screws on on the left inside panel, then the right side. Lean front out a little and remove the two wires one the back...
Read more
More
$14.95
- Compare At:
-
$17.94
- You Save:
-
$2.99
Genuine Whirlpool part
By: Whirlpool
Part Number: 349241T
Rear drum support roller kit for dryers. Mounts behind the drum to maintain alignment and smooth rotation. Replace when rollers are worn or damaged.
Do-It-Yourself Stories from Customers like You
Thumping/vibrating/rattling pretty bad fixed 100%! Doug P. • Durham , NC • November 15, 2015
I am very glad to find the AppliancePartsPros.com website! Their instructional videos and easy parts reference made all the difference. I had originally planned to have someone come to fix my dryer, but no one was available for at least a week. I checked out their site, and after watching the videos I felt confident I could repair my appliance. I determined that a drum roller wheel had gone bad. Apparently it was going bad over the last five years since the dryer always seemed to rattle a...
Read more
More
$18.23
- Compare At:
-
$21.51
- You Save:
-
$3.28
Genuine Whirlpool part
By: Whirlpool
Part Number: WP691366
Idler pulley maintains belt tension in your dryer drum assembly. Replace if the wheel is cracked, bracket is broken, or pulley has worn bearings.
This part fixes the following symptoms
-
Will not tumble
-
Takes too long to dry
See more...
Do-It-Yourself Stories from Customers like You
Thumping/vibrating/rattling pretty bad fixed 100%! Doug P. • Durham , NC • November 15, 2015
I am very glad to find the AppliancePartsPros.com website! Their instructional videos and easy parts reference made all the difference. I had originally planned to have someone come to fix my dryer, but no one was available for at least a week. I checked out their site, and after watching the videos I felt confident I could repair my appliance. I determined that a drum roller wheel had gone bad. Apparently it was going bad over the last five years since the dryer always seemed to rattle a...
Read more
More
$15.95
- Compare At:
-
$19.14
- You Save:
-
$3.19
Genuine Whirlpool part
By: Whirlpool
Part Number: 279827
Dryer won't start or stops mid-cycle? A worn drive motor is often the cause. This motor turns the drum and circulates air. Moderate DIY repair.
This part fixes the following symptoms
-
Will not tumble
-
Noisy
-
Shuts off too soon
See more...
Do-It-Yourself Stories from Customers like You
High pitched squeal: maybe a roller wheel maybe a bad felt bearing on drum maybe a rubbing fan wheel or just a burned out motor! Bruce K. • Pikeville , KY • September 06, 2014
My 12 year old Kenmore dryer problem started about 3 years ago with the motor just stopping.
My thing was:
I would turn it off and turn the drum by hand about halfway around and it would work again.
Last month, my wife said it stopped again and its making a loud noise,
but when I did "my thing" it still made a loud squealing noise (like I was killing a mouse).
I made time to work on it the next day, I took it apart, using the video instructions from AppliancePartsPros, I removed the top,...
Read more
More
$97.47
- Compare At:
-
$131.61
- You Save:
-
$34.14
Genuine Whirlpool part
By: Whirlpool
Part Number: 279570
The Door Latch Kit is an OEM replacement part for Whirlpool washers. This component is responsible for securely locking the washer door during the wash cycle, preventing it from opening unexpectedly and ensuring a safe and efficient operation.
Symptoms of needing to replace the door latch kit include:
- Difficulty in closing or latching the washer door
- Door opening unexpectedly during the wash cycle
- Leaks or water seeping due to an improper door seal
- Excessive wear or damage to the latch components
Causes of a faulty door latch kit can include normal wear and tear over time, physical damage due to impact or mishandling, or issues with the door alignment or strike plate.
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore washer models.
This part fixes the following symptoms
-
Door won't close
-
Shuts off too soon
-
Doesn't shut off
-
Takes too long to dry
See more...
Do-It-Yourself Stories from Customers like You
Dryer door latch worn out Kathy M. • San Diego , CA • February 22, 2015
When I looked up the part number there was a handy video that popped up. I watched the video and thought "how easy!" so, I ordered that part and waited. The next day, I thought I better start to take the door off of my dryer (because that's what the video instructed, and I wanted a head start) so as I was going into the garage to get my tools, my son came in with a small package. It was the part. That came, to quote another customer, "Crazy Fast!" All the way from Kentucky to California! ...
Read more
More
$9.55
- Compare At:
-
$13.85
- You Save:
-
$4.30
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3390719
The Thermal Fuse is an OEM part for Whirlpool dryers. It is a critical safety component designed to protect the dryer from overheating by blowing and cutting off power if the temperature exceeds safe limits. This disposable, one-time fuse is essential for preventing potential fire hazards and ensuring the appliance operates within safe temperatures.
Symptoms of a bad Thermal Fuse include:
- The dryer not starting or suddenly stopping during a cycle
- No heat being produced while the dryer is running
- Unexplained cessation of all dryer functions
Causes of a bad thermal fuse can stem from restricted airflow due to lint buildup, a malfunctioning heating element that causes excessive temperatures, or other electrical issues within the dryer.
This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
This part fixes the following symptoms
-
No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You
My maytag bravos xl dryer would not dry properly it would run but with very little heat cycles were twice as long as previous to get clothes dry Mike C. • Lawrenceburg , IN • May 11, 2015
I replaced the "heating element" which was bad.........as well as the "Thermst-fix" and "Thermal Cutoff" which are located on the side of the element mounting location while I had the dyer all opened up and the element mounting tube removed.......I also replaced the Dryer Thermister which is located on the top of the blower fan.....To get to these parts, you must open the top of the dryer which has spring latches on both sides of the front corners... they need to be pressed in (use a putty...
Read more
More
$20.38
- Compare At:
-
$24.05
- You Save:
-
$3.67
Genuine Whirlpool part
By: Whirlpool
Part Number: 239087
Seals the rear drum opening to prevent air leaks and reduce noise. Replace if worn, frayed, or causing rattling sounds. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Noisy & inefficient Richard M. • Indianapolis , IN • December 06, 2016
After having replaced the drum support rollers twice in a roughly 3yr period, I realized something wasn't quite right, and indeed it wasn't. I had been ordering the wrong parts - I did use the online parts locator after checking, & double checking my model number. Apparently my older Whirlpool dryer has a somewhat ambiguous model number because the rollers that were shipped each time looked nothing like the originals. I realize that is not particularily uncommon - manufacturers often modify...
Read more
More
$46.35
- Compare At:
-
$58.24
- You Save:
-
$11.89
Genuine Whirlpool part
By: Whirlpool
Part Number: 279264
Replaces worn dryer front bearing and seal that cause squealing or scraping noise. Essential for smooth drum rotation. Confirm fit with your model.
Do-It-Yourself Stories from Customers like You
Noisy & inefficient Richard M. • Indianapolis , IN • December 06, 2016
After having replaced the drum support rollers twice in a roughly 3yr period, I realized something wasn't quite right, and indeed it wasn't. I had been ordering the wrong parts - I did use the online parts locator after checking, & double checking my model number. Apparently my older Whirlpool dryer has a somewhat ambiguous model number because the rollers that were shipped each time looked nothing like the originals. I realize that is not particularily uncommon - manufacturers often modify...
Read more
More
$67.95
- Compare At:
-
$80.18
- You Save:
-
$12.23
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3394508
Supports the front drum edge for smooth, quiet rotation. Replace when worn to stop scraping noises or drum wobble. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Drum rear seal worn front bearing same Joseph M. • Conshohocken , PA • February 20, 2015
Replace parts worn i repair appliance for60 years i am79
Read more
More
$60.52
- Compare At:
-
$72.62
- You Save:
-
$12.10
Genuine Whirlpool part
By: Whirlpool
Part Number: 8212614
Lint brush tool for cleaning dryer vents and lint traps. Replace your worn or missing brush to maintain proper airflow and remove built-up lint deposits.
More
$24.95
- Compare At:
-
$29.94
- You Save:
-
$4.99