Poulan Hedge Trimmer Parts

Fuel pickup filter draws gas from tank to carburetor. Replace if engine won't start or runs poorly due to clogged filter. Verify fit with your model number.

Ignition module for gas leaf blowers and trimmers. Works with flywheel to create spark timing. Replace if damaged by heat exposure or engine won't spark.

If your chainsaw rope won't retract after pulling, the starter spring likely needs replacement. This spring creates the recoil to start the engine.

Engine piston kit for gas trimmers and outdoor equipment. Replaces worn, damaged, or corroded pistons that cause poor compression and engine performance.

Primer bulb assembly kit for chainsaws. Installs on the carburetor to circulate fuel for easier starting. Replace if bulb is cracked, hardened, or worn.

The carburetor kit has a metal body that is designed to withstand high temperatures, a rubber primer bulb, and a plastic throttle lever. The carburetor is an integral part of engines in lawn and garden equipment. This is where the air and fuel will be mixed before being sent into the engine. The air comes in through the intake tube, and it flows into a smaller tube, where the fuel is injected through small holes in the carburetor body. Then, the two are mixed and released into the engine through a butterfly valve, which controls the amount of fuel going to the engine for optimal performance. The carburetor can become clogged over time or even be broken or damaged. If the engine is not running properly, the carburetor may need to be replaced. This is a simple replacement that only requires a screwdriver. Make sure to always disconnect the spark plug and wear gloves when performing engine repairs. This kit can be used with several models of lawn and garden equipment, including brands like Weed Eater, Paramount, Poulan, Jonsered, and Husqvarna.

Piston ring seals the space between piston and cylinder wall in gas-powered outdoor power equipment engines. Replace if worn, cracked, or causing smoke.

Engine won't engage when pulling starter rope? The starter pawl bridge connects the flywheel to spin your trimmer's engine. Easy DIY repair.

Carburetor gasket creates an airtight seal between the carburetor and adapter for proper compression and airflow. Replace if engine misfires, idles rough, or is hard to start. Verify fit by model number before ordering.

Seals the carburetor adapter to prevent dirt and debris from entering your chainsaw engine. Replace if cracked, brittle, or leaking. Confirm fit by model.

This ball bearing and seal are used in a range of chainsaw models. It acts as part of the blade assembly and is designed to both lessen friction and stabilize moving parts. This bearing is also set within a race and the entire race/bearing/seal assembly must be replaced at the same time. The bearing is encased with a rubber seal, which prevents fuel leakage and keeps the engine working smoothly. It does not impede the bearing as it turns. Ball bearings are placed in high contact areas and wear down due to friction. They need to be regularly replaced for optimal performance. If the engine shows difficulty while running, or is louder than usual, the seal or bearing may have worn down. This OEM replacement part is sourced from the manufacturer and works with certain models of Poulan small engines, including the Poulan/Poulan Pro 2900, and Husqvarna chainsaws. This part replaces parts 530019259 and 530047827, both of which are obsolete.

Fix a broken or missing pull start handle that prevents engine starting. This chainsaw starter handle works with the recoil assembly for reliable starts.

Carburetor adapter for gas line trimmers and leaf blowers. Connects the carburetor to the engine intake. Replace if cracked, broken, or deteriorated.

Engine gasket kit seals your hedge trimmer's engine to prevent damage. Replace if you see smoke from exhaust or oil leaks. Verify fit with your model.

Vibration-dampening spring assembly that installs between the engine and handle. Replace if springs are broken, worn, or missing to restore proper isolation.

Replacement fuel cap for hedge trimmers and leaf blowers. Seals the fuel tank to prevent gasoline leaks. Replace if cracked, broken, or worn threads.