Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Control Unit by Bosch

Best Seller
Manufacturer Part
4.89 (64)
By: Bosch
Part Number: OEM8502168
Manufacturer Part Number: 00431692

Questions & Answers

For Bosch Control Unit (Part Number: OEM8502168)

Joe for Model Number shy56a05uc/23

Started dishwasher this morning, came home 8 hours later to find the drain pump still running. I pulled drain screen and basket out, only to find very little water in by impeller cavity (less than 1/4" water). I soaked up the little water that remained in the cavity, but it did not affect the operation of the pump, so I think that rules out the pump switch. the on/off switch works but the control panel does not light up. The only light on the control panel that illuminates is the "wash" cycle indicator. The pump goes on & off when I cycle the "on/off" switch. Thanx for the help/Joe

1 Answer

Hello Joe,
This sounds like you have a leak into the main base. This will activate the flood switch and the unit will sit and run the drain pump indefinitely. This is normally caused by a bad water inlet valve. If the water valve doesn't open fully because of mineral deposits or sedimentation from the water supply, the incoming water will "dribble" from the side into the main base. When enough water accumulates in the base to raise the flood float, the issue you are describing occurs. The fix is to replace the water inlet valve 00425458 and dry out the main base. You can take the easy way out and set a fan in front of the unit, blowing into the main base, for at least 24 hours. This will normally evaporate the excess water in the base if the air is blowing into the main base across the standing water. The other option is, while the water valve is off of the unit, use the corner of a towel to "wick" the water out of the main base.

Read More...

1 Answer

Hello Steve. If the unit is not getting water to run, then the motor does not run. You will need to test and see if there is power coming to the water valve. If so, and the water valve does not fill the tub assembly, you will need to make sure the water is turned on since you have already replaced the water valve in the unit. If there is no power, and the float switch is good, you will need to make sure there is no wiring issue and if not, replace the control module in the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Read More...

1 Answer

Hello Rich,

The numbers on a part are normally manufacturers' numbers. They mean nothing to the appliance world unless you are a vendor that is making the part for the manufacturer of the appliance. Once used in an appliance, the appliance manufacturer assigns a new part number for ordering purposes.The control 00431692 you listed is the correct one for your model.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google