Jane January 20, 2020 for Model Number Dacor oven CPS127 and CPS 130 The displays on both of my ovens is too dim to read. Can this be fixed? Also, the temperature 'down' arrow on the CPS 130 does not respond reliably. Can that be fixed? Thank you! Jane
1 Answer Jane, Unfortunately, the control panel with membrane switch would need to be replaced and is no longer available. Read More...
Andrew November 17, 2019 for Model Number RSG30ss The disply on our Dacor oven/stove is not working at all. The oven and stove as well as the oven light works as well. Would this mean we need to replace the display ? if so, what do you know the part number ? thank you
1 Answer Andrew, Based on the info supplied the manufacturer has discontinued the part and has not made a suitable replacement available. 62789 no longer available Read More...
Bruce November 02, 2019 for Model Number ERSD30 Gas stove top, electric oven range. Turn on any mode for the oven (bake, convection, etc.), set temp. (say 350), pre-heat cycle displayed, the "ON" displayed and then mode cancelled after about 5-8 seconds on pre-heat. Mode and temperature blank out. All modes respond the same. Relay board and over temp sensor have been replaced. No tone, but looks like Cancel selected. Intermittent as well, so sometimes it works and sometimes not. Thoughts?
1 Answer Bruce, based on the information provided, the most likely failure would be in the ERC oven control 62692. The membrane keypad 62301B can be inspected for any visible damage to the ribbon or keypad, but as there is no tone being sounded this would make it more likely the control. Unfortunately, these parts have been discontinued by the manufacturer and are no longer available. Read More...
Tom September 12, 2019 for Model Number Dacor ERD30S06 Everything works except for the up/down arrow touchpad keys. For a time, they were finicky (temp would bump up/down on it's own until the oven accepted it). Now, everything else works (no error codes) except that one can't set the temp. The control panel simply times out after 20 seconds of so and turns off. Is this likely the touch membrane or the main circuit board?
1 Answer Tom, It would definitely be the touch membrane switch. Unfortunately, this part is no longer available and no satisfactory replacement has been provided by the manufacturer. Read More...
Jason M. May 18, 2018 for Model Number Dacor mov230s double oven It looks like you are out of stock. Any idea when it will be available? The top oven doesn’t hold temperature. The bottom oven nothing works no lights no fan and no heat. I’d appreciate any help you might offer. The branch circuit feeding the oven is the correct 220Vac.
1 Answer Hello Jason, I'm sorry but this part has been discontinued by the manufacturer and no satisfactory substitutions have been provided. Thank you for your patience and understanding in this matter. Read More...
Craig April 24, 2018 for Model Number EO230SCH Had a U43 error, replaced relay board 101559. Restored power, now display is blank, nothing lit, dead. After about 3-4 minutes the cooling fan will start, otherwise nothing. Original relay board p/n is 72720. Is there a reset needed? I reinstalled the original board, same result, nothing but the fan starts after 3-4 minutes like the new(reconditioned) board. Verified voltage to terminal block, checked and rechecked all connections.
1 Answer Craig, For this issue there would not be a reset and will want to check the wiring between the relay board and the display. Read More...
Bill J. April 09, 2018 for Model Number Dacor EGR30 The control panel for my Dacor EGR30 range needs to be replaced. What do I need to do in order to gain access to the control panel so that I can replace it?
1 Answer Hello Bill, If you remove the knobs you will find that one of the screws under each actually mounts the panel in position. There are also normally a couple of screws under the control panel accessed by opening the door and looking straight up at the bottom of the panel 26790E. Read More...
Rose Cristello December 10, 2017 for Model Number WALL0 Oven keeps beeping and indicates "U43 Relay Board"
1 Answer Rose, We will need to have the model number to assist properly with your question but based on the code sounds like an upper relay board has failed. Read More...
Mark November 21, 2017 for Model Number CPD227 What is the part number for Dacor CPD227 Control Board and the ribbon connector?
1 Answer Mark, The part number for the oven control board is 62681 which has been discontinued by the manufacturer with no suitable replacement available. Read More...
Monique November 09, 2017 for Model Number MORS130S Dacor Renaissance wall oven We replaced control board and relay board. Now power comes to the panel and time is displayed. But...all we can do is hold down secure/cancel button which switches in from Off to on. No other buttons on control panel are working!! Ugh!!
1 Answer Monique, The part number that would most likely be needed would be a faulty membrane panel kit DE81-04981A. Read More...