Darryl October 22, 2012 for Model Number 790.96010400 Kenmore stove, oven not working and clock stop working, blank screen!!! However, eyes are working!!!
1 Answer Hi Darryl, most likely your oven control 316557118 has failed. The top elements are control by your infinite switches so they were not affected. Thanks! Read More...
Matt September 22, 2012 for Model Number 790.92202011 The wire running from the control panel to the back element is burned right at the control panel. What would cause this and can I just replace the control panel?
1 Answer Hello Matt, Excessive current flow is what caused the wire to burn. You need to use a test meter to insure the wire isn't shorted to ground. If it isn't, check the component that the wire attaches to or a bad part. If it was shorted, it could be open now and also in need of replacement. As far as the control replacement goes, you need to determine what the terminal powers and the voltage which should be supplied from it and test to be sure it is supplying the proper voltage or return resistance. If it is operating properly, the terminal can be sanded to expose shiny metal and the spade connector on the end of the wire replaced and used as is. Read More...
Dale August 13, 2012 When the oven is set to 350, the temp in oven continues to rise. There was a F10 code shown in display. I tested the temperature sensor probe with meter and got a reading of 1,058 ohms which is within the limits. Would next area to look at be the electronic control board?
1 Answer Hello Dale. Yes, if the sensor test good, you will need to order and replace the clock timer 316557118 on the unit. Read More...
Lanny April 16, 2012 for Model Number kenmore gas range I had a power outage on friday the 13th. Now my stove is showing a F13 code. I tried to reset it but leaving the power off for 5 min. Then press stop to clear the code, still shows F13, please help. This stove is only 1 1/2 years old, yes its out of warrenty. Anything would be a help, Thank you.
Joe September 16, 2011 for Model Number 79096009600 I just replaced the heating coil because it blew in half. The oven is still not heating. Even though the top of the range and visually everything is on can the control panel still be bad for the oven heating part?
1 Answer Hello Joe. Yes, based on the information you provided, you will need to order the clock assembly 316557118 and replace the clock. Hope this helps. Read More...
Richard B. May 04, 2011 for Model Number 790.92204012 What if I receive the wrong part, can I send it back?
1 Answer Hello Richard! Please see the following link to view our return policy, thanks! http://www.appliancepartspros.com/customerservice/returns.aspx Read More...