Tom March 16, 2017 for Model Number LTF2940FE1 Appliance pump makes a loud noise when turned on in any mode. It only pumps when I wedge something under it but still makes a funny noise and never stops.Think its the pump but thinking it could be a double issue like the pump and a sensor or control board issue.
1 Answer Tom, With the noise that is going on when the pump is running would most likely be caused by a faulty pump. If the pump never shuts off then this would likely be caused by a faulty main control board. Read More...
Kitt March 07, 2017 Frigidaire front load washer, do not know the model number ,need to replace the control board .the original part number is 134847902.Which part number is compareable ?
1 Answer Hello Kitt. The part number provided is not good. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Charles N January 19, 2017 for Model Number GLTF2940EE The machine will not go to Spin cycle.Everything is good; ie, Pump, Door Switch, etc. No voltage to the switching Mech. Will not change speeds on spin cycle-will not even engage.
1 Answer Hello Charles. If you are sure the unit is draining good and the door switch is good, you will need to replace the control board on the unit. Read More...
Thomas Appliance Service November 15, 2016 for Model Number GLTF294CES3 Frigidaire front load turn off when 7 come up on timer.
1 Answer Thomas, If the unit is shutting off with a 7 on the display then it would be suggested to check the door lock assembly and if this checks ok then the control would likely be the issue. Read More...
Kimberly November 07, 2016 for Model Number MVWX500XW0 I turn on my washer all lights come on lid locks then a few sconds later the lid unlocks.Will not wash or spin. All lights stay on untill I turn the power off
1 Answer Kimberly, You will want to put the unit into a diagnostic mode and see if there are any error codes that are stored. If there are any error codes then this will tell you where to proceed with testing the unit. Read More...
Stewart October 02, 2016 for Model Number 11045089400 When I push the start button most the time I can't get the initial click sound for start when this happens if I hit the top of the machine real hard it will click and work is this first relay that energizes in the control board.
1 Answer Hello Stewart, You will need to order and replace the control board in the unit. Read More...
Lisa August 30, 2016 for Model Number GLTF2940FS2 About 2-3 seconds after starting the washer all the lights go out except no spin, start light and door lock. Water does not start. Thanks!
1 Answer Hello Lisa. See if there is power to the valve. If not, it sounds like the control board has failed and will need to be replaced on the unit. Read More...
Tony August 22, 2016 for Model Number LTF2940FS1 Figidaire Cannot get any agitation during cycles. Replaced motor, water control valve, drain pump and door latch. still no agitation. drains well but no spin.
1 Answer Hello Tony. Based on the information you provided, either the wiring harness or the MCU 134743500 is bad on the unit. Check the harness and see if it is good. If so, replace the MCU. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Dennis July 29, 2016 for Model Number fffw5000qw Machine starts, runs about 4 min. then quits. has a code e00.
1 Answer Dennis, The E00 is not an error code, on the model number you supplied. It may mean no error codes logged, on other models. Based on your description, you may want to remove power,the top panel and the control panel and buttons. The check and make sure the buttons are not sticking down, and the return spring assembly, doesn't have any broken or cracked tabs or seams, causing a button to remain partially engaged/depressed. Read More...
Cj July 23, 2016 for Model Number frigidair washer My washer comes on in any cycle for a few seconds then shuts off then repeat again.
1 Answer Hello CJ. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...