Henry F. March 29, 2015 for Model Number FFU21F5HWB The freezer was too warm. The control board was on #4, But could not change. Unpluged the control board on front door of freezer And pluged back in. It reset and was able to adjust, the freezer came on. Should I replace it? Thanks
1 Answer Hello Henry, It sounds like you reset the control to factory default by discontinuing power to it. Watch it closely for a week or so. If it does it again, I would replace the control 297370600. Read More...
James February 24, 2015 for Model Number Frigidaire upright freezer LFFU14F5HWG Control module numbers can no longer be read it just keeps flashing parts of numbers or letters. It was replaced under warentee 6 months ago and has worked fine until now. What caused this and should I replace it or is ther another problem with the freezer the freezer is cold now?
1 Answer Hello James. It may be an error code for the unit. If not, then it sounds like the board will need to be replaced once again. Read More...
1 Answer Hello Billybob. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Mr. Fixit October 15, 2014 for Model Number ffu14f5hwb Freezer has shut down by itself on several occasions over the past 3 months. Has restarted after unplugging and replugging. Now that doesn't help anymore. lights are flashing (hi temp and door ajar) but no temp setting shows in display and compressor is silent. Tried leaving it unplugged for 30minutes to "reset" as some people advised- no good. Could this be the control panel? Thanks.
1 Answer Mr. Fixit, Yes, the issue could be and most likely is the control board 297370600. Power (120 VAC) is supplied top the control on pins 2 and 8, then the board distributes power to all the components in the freezer. Check for voltage into the control board and/or replace it, and you should be fine. Read More...
Rich S October 09, 2014 for Model Number LFFU17F5HWC What do I need to do to replace the user control board? Does your replacement come with instructions? Thanks
1 Answer Rich, To remove the control board from the door you simply need to get a flat blade behind it and pry it out. Then just push the new one into place. Read More...
Robin A September 15, 2014 for Model Number L44U17F5HWC We had a power surge and it burnt up the user control board. I bought a replacement but when we took the old one out to replace it, the pins in the door that it connects to was burnt and melted. My question is....Do you sell the part located in the door that has the pins that you connect the user control board to?
1 Answer Hello Robin. In order to get that part, you must order the outer door 297316501. Read More...
Samuel August 04, 2014 for Model Number Frigidaire Freezer (FFU14F5HWF) On the temperature control on the outside of the door, the square lights by the Hi Temp/Door Ajar blinks. The freezer is not coming on. No control/readout on temperature control to change temperature and it will not react when I try to reset it. The inside light of freezer would not light on when I open the door. When I moved freezer to find the cause, I found something like a ring on the floor where the freezer was. I researched and found out that something like a ring is possibly the broken part of control temperature (216788000). I have three questions. 1. Do you think that I need to change control temperature? 2. If so, is 216788000 right part number for my Frigidaire Freezer? 3. I tried to found out where control temperature is, but I could not find it at all. Where on earth is this control temperature located? Thanks
1 Answer Hello Samuel, The temperature control on this model is the electronic control 297370600. You should also test the door switch 216822900. Read More...
Hugh July 10, 2014 for Model Number LFFU17F5HWH We had a couple power surges. Freezer died. Control panel displays gibberish and does not seem to do anything. Compressor won't come on at all. Have unplugged and replugged, but nothing. I'm thinking new control panel 297370600. You? Thanks
1 Answer Hello Hugh. Yes, it sounds like the control board is bad and will need to be replaced on the unit. Read More...
Sinh June 11, 2014 for Model Number LFFU1765DW11 I have a frezer model < lffu1765dw11> . It would run for a day or 1/2 day then stop , things are almost melted out , then it run again . If i tap on back of frezer , it would run again .
1 Answer Sinh, In most cases when this issue occurs it is caused by the defrost timer sticking which is part number 5304518034. Read More...
Raf June 09, 2014 I have a Frigidaire freezer and the door was probably left open. Now the high temperature indication is not going away. It cool inside but not enough for a freezer. What do I do?
1 Answer Hello Raf, This is most likely a control failure. If the model number from the units' I.D. tag had been posted we could say for sure the part you were looking at is correct for the model. Read More...