David September 19, 2013 for Model Number FGGF3054KFC Our oven had erratic temp fluctuations and now won't work at all. Temp probe and gas valve both test with proper ohm reading. We had a repair man look at it but he wanted to replace the gas valve. He tested ignitor and said it was drawing proper amperage. Should I recheck ignitor or is it most likely the circuit board?
1 Answer Hello David. Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve. If the voltage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Chuck May 29, 2013 for Model Number fjjf3054kfh Stove will not work. No lights, sounds, or anything but the igniters will spark. Fridgidaire FGGF3054KFH Model number
1 Answer Hello Chuck. Based on the information, the controller 316560106 is bad and will need to be replaced on the unit. Read More...
1 Answer Hello Luke. This is not hard to install. You will disconnect the power and pull out the range. Then remove the panel on the back of the range to access the clock. Once removed, you will remove the screws securing the clock to the control panel. Then remove the wires and install them onto the proper terminals of the new clock. Read More...
Ray November 06, 2012 I was cleaning my Frigidaire gas range (Model # DGGF3054KFE) and had to move the Oven Igniter. In moving it, the Oven Igniter touched the oven metal and I heard a sparking sound. Now the oven is completely dead. None the burners will turn on (top or oven). None of the lights go on, not even the clock. The control panel is completely inoperative. What may be wrong? Could it be the EOC?
1 Answer Hello Ray. Test and make sure the power is coming to the unit. If there is power there, and the clock does not work, you will need to replace the clock assembly on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...