Dennis September 10, 2012 With dryer off washer does nothing.With dryer on washer will fill with water and pump out when selected but nothing else.
1 Answer Hello Dennis. It sounds like a wiring issue. You will need to check for shorted or cut wiring causing an issue with the unit. Read More...
Curtis N August 02, 2012 for Model Number FLEB43RGS3 The washer rinses however after the rinse the unit will not spin and discharge the water. I have replaced the timer already.
1 Answer Hello Curtis. Based on the information you provided, you need to check and make sure the drain pump is working and the lid lock assembly 134101800 is good on the unit. Read More...
Ray S. May 12, 2012 for Model Number Stackable gallery stackable washer and dryer My dryer works but washer will not start at all ?
1 Answer Hi Ray. If you do not have any water fill and also do not hear a water valve humming.... Then you need to replace the timer part # 131758600. Was the timer rattling or buzzing before it went out ? Thank You. Read More...
Nrivera May 11, 2012 for Model Number FWS235FRS6 My wasking machine starts to collect water in order to wash the clothes, however at the same time it starts to remove the water through the hose. How can I fix this?
1 Answer Hi Nrivera. This is called a siphon lock where there can be a couple of things to check. Is the drain hos pushed into the drain stand pipe too far. Is there a air gap (needed) in between the drain hose and the inner sidewalls of the standpipe ? Lift up on the hose and make sure there is only approx. 6" of hose into the pipe. Try this while filling to see if it now allows the tub to completely fill . Use a tie wrap to secure the hose correcty. Use drain-o in the stand pipe and follow directions as well. Thank You. Read More...
Darcy April 23, 2012 for Model Number FWS833AS1 I start the washer, it will wash until it gets to the 8 minute mark and then will stop. I tried advancing the knob to other cycles and nothing happened, so I moved it back to the 8 minute mark, then all of the sudden the washer started and completed the cycle. Does it sound like this could be the timer going out?
1 Answer Darcy, Yes, it does sound like a faulty contact in the timer 131758600, especially since the washer ran a complete cycle after you manipulated the timer. Good Luck and Thanks Read More...
Terry December 02, 2011 for Model Number fws833asa2 my washer start but stays in that one position is this the timer if so how do i replace it
1 Answer Terry, If the dial or timer never advances(moves) then the timer 131758600 is the most likely issue. Here's some information from the service manual "Removing the timer (some models) 1. Disconnect the washer from the electrical supply. 2. Remove the rear panel from the console and the timer knob and skirt. 3. Unplug the wiring harness from the timer. 4. Remove the screw holding the timer to the console front panel. 5. From the rear of the console lift timer locking tab and slide the timer to the right to release it from the control mounting plate and pull back on the timer. Timer knob: (some models) 1. The timer knob is held on to the shaft by a locking rod that extends to the rear of the timer. To remove the knob, using a small screwdriver pull the locking rod backwards to release the knob. Pull the dial skirt straight out to remove it from the timer shaft assembly." Good Luck and Thanks Read More...
Frank November 07, 2011 for Model Number FEX831CSO The washer agitates only on the rinse cycle. It will not agitate when the tub is filled or the wash cycle
1 Answer Hello Frank. If the washer agitates in the rinse cycle, but does not in the wash cycle, you will need to replace the timer 131758600. Hope this helps. Read More...
Tina October 28, 2011 for Model Number FEX831FS2 The washing machine fills up with water washes and then stops. It does not do anything else, no sound, nothing.
1 Answer Hello Tina. You will need to check and see if the lid switch 134101800 is bad on the unit. If so, it will prevent the unit from spinning out. If you can advance the timer, and the unit will spin out, you may have a bad timer 131758600 on the unit and the timer will need to be replaced. Hope this helps. Read More...
John October 16, 2011 for Model Number FWX833AS1 Hi, the washer fills up and is fine until right before it goes to rinse. It just simply stops does don't drain or do anything else.
1 Answer Hello John. You will need to check and see if the lid switch 134101800 is broke and bad on the unit. If so, it will cause the problem you are having. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
John October 04, 2011 for Model Number wws833es1 Knob is pulled out, no water enters ,lid is closed and agitator rotates. Is timer bad?
1 Answer Hello John. Based on the information you provided, it sounds like the pressure switch 134411600 is bad and will need to be replaced. Hope this helps. Read More...