Wade December 03, 2018 for Model Number GE PSW23PSRASS Continue my GE Profile PSW23PSRASS temp control showing OFF question. It works and cools okay. Recently, Temp Control Touch pad sometimes shows "OFF" by itself. I can turn it back by selecting COOL to reset temp (0F for freezer and 37F for refrig). It sometimes does this in four or five hours, sometimes in half day - no patterns. It does not seem power issue (from main board to display/touch pad), as pad display is powered on the whole time. I bought a replacement part# WR55X10389. Once installed and powered on, it has THREE ZERO flashing on both freezer and refrig temp control. I know ONE ZERO flashing is in test mode. Is this new part not reset to 0F / 37F, thus need reset? If so, how? or this is a defect part. By the way, this particular part is not bought here. Thanks
1 Answer Wade, This issue will most likely be caused by a faulty bracket and OV WR55X10389 that would be faulty. Sounds like a stuck keypad. Read More...
Wade November 30, 2018 for Model Number GE PSW23PSRASS GE Profile PSW23PSRASS works and cools okay. Recently, Temp Control Touch pad sometimes shows "OFF" by itself. I can turn it back by selecting COOL to reset temp (0F for freezer and 37F for refrig). It sometimes does this in four or five hours, sometimes in half day - no patterns. It does not seem power issue (from main board to display/touch pad), as pad display is powered on the whole time. Thank you
1 Answer Wade, This issue would most likely be caused by a sticking key on the touchpad and would need to replace the dispenser control board WR55X10435. Read More...
Deb C March 19, 2018 for Model Number PSW23PSRASS The display does not work for the temperature and the door display for the ice and water is not working. Everything cooling fine and it's making ice you just can't use the controls on the door to get ice and you can't see the temperature.
1 Answer Deb, For this issue the most likely cause will be the main control board which will be part number WR49X10152. Read More...
Steve B. December 11, 2017 for Model Number PSC23SGPASS Both the freezer and refrigerator temperature display indicates off and the temperature reads 43° but none of the controls work. The refrigerator was still cooling/freezing but now that has stopped as well. Thanks
James June 25, 2016 for Model Number GE Artica My GE refrigerator has the temperature control panel that is part # AP3778023. The refrigerator temperature lower button works but the temperature higher button won't respond. So I can't turn the temp up and it is set too low. Is there a way to reset the temp to the initial 37 degree setting? If not should I try replacing this part or would it be the main control board? Thank you
1 Answer James, You're on target, you'll need the WR55X10389, The main control board on the back of the machine, shouldn't be an issue at all. Being a refrigerator, if you remove power for a few minutes (10 - 15 min.) then restore power then try and program the control. Read More...
Fred June 07, 2016 for Model Number PSC23NHPABB My GE Artica stopped cooling this past weekend. Lights come on, displays are working, but the compressor will not start. I replaced the start relay to the compressor, but it still will not start. The compressor is not making any noise, and none of the fans are running.
1 Answer Test for power to the compressor. If none is there then it sounds like the main board will need to be replaced on the unit if the unit is turned on. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Colin February 20, 2015 for Model Number PSC23SGPASS The Main interior light is out (checked bulb it is OK) the display panel is dark and will only light up for a few seconds when pushed. Pushing any button has no effect. The Refrigerator hovers at 41 degrees (set at 37). The Freezer side works OK. I replaced the Main board and the issues still remain. Any Advice?
1 Answer Hello Colin, You should check the J7-6 terminal for 120Vac. Since the circuits are different but come from the same board, I am questioning the integrity of the new board you installed. Read More...
Dar C. August 16, 2014 for Model Number GE PSI23SCPA BS Starts to defrost and does not turn back on. Unplugged it for an hour and it reset. We have had to do this last month and also yesterday. What needs replacing? The Interface Assembly? Thank you
1 Answer Hello Dar, This is most likely a bad relay on the main control board WR55X10942C. Read More...
Geoff March 09, 2014 for Model Number PSC23SGRC SS Suddenly, Fridge "control panel" at top inside fridge and icemaker displays are dark -compressor not working - interior lights work - do I just need new control board ? Thanks
1 Answer Geoff, Based on the information it sounds like the main control board will be the issue with the units display board going black and the compressor not running. You can check on the control board from J4 pin 1 to 2 for 12 to 24 vdc and if there is not voltage then the main control board is faulty and would need to be replaced. Read More...
Jerry C October 22, 2013 for Model Number PSC23NGNA BB The temperature on the refrigerator continues to drop down to 30 to 31 degrees after being reset to 37 on the Bracket and OV panel. It does not matter how many times that I reset the temp, it always drops. Should I replace this panel or is there something else that I need to change.
1 Answer Jerry, You will want to pull the damper assembly WR49X10091 from the refrigerator section and check to see if the damper door is broken. If the damper door is broken then replace the damper. Read More...