Pjr October 19, 2011 for Model Number JVM1540DM1BB When I plug my control panel in, it tells me there is a short, service may be needed. Do I need to change the control panel, the touch pad or the smartboard?
1 Answer Hello PJR. Based on the code you are getting, it sounds like the control panel WB07X11008 is bad and will need to be replaced. Hope this helps. Read More...
Victor October 09, 2011 for Model Number JNM1541DNBB Hello, Does the control panel have a 16 or 13 prong ribbon which plugs into the controler board, in my microwave the ribbon has 16 leads. I bought part WB07X11008 which is also a control panel but it has a 13 prong ribbon. Thanks
1 Answer Hello Victor. WB07X11008 has 13 and is the correct panel according to your model number. Hope this helps. Read More...
K. A. P. June 19, 2011 for Model Number JVM1540DN1BB Can't get the control panel off. The screws will not move.
1 Answer Hello K. A. P. You will need to remove the screws holding the vent in place. Then remove the screw holding the control panel in place at the top of the control panel. The control panel will lift up and off of the microwave. Hope this helps. Read More...
Al June 17, 2011 for Model Number JNM1541DN1BB Nothing on the touch pad works except the clock button, but you can't set the time because the numbers do not work. Would that indicate the need to change the touch key pad or is there something else I should check?
1 Answer Hello Al! Disassemble the control panel and make sure that the connection from the touch panel cable to the control board is firm and there are no corrosions. If the cable is ok, replace the touch pad assembly WB56X10822. Thanks! Read More...
David March 26, 2011 for Model Number JVM1540DN1BB WILL THE CONTROL PANEL AP399440 WORK ON THIS UNIT?
1 Answer Hello David. No that is not the correct control panel for your model JVM1540DN1BB. The correct part number is WB56X10822. Hope this helps. Read More...