Nick February 22, 2012 for Model Number PDW9980N00SS My dishwasher does not have any power. I check the plug and there is power the display is dead. I am thinking that the controler is bad, if you think that is the case could you please tell me were is located?
1 Answer Hello Nick. Test the door latch switch WD13X10031 and make sure it is good. If so, and there is power to the module WD21X10370, you will need to replace the module. You will need to remove the inner door liner to access and test both of these parts. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Gary C. December 30, 2011 for Model Number WD21X10367 This is the GE part # for the dishwasher control module. My question is can this module be repaired?
1 Answer Hello Gary. No, if the module is bad, you will need to replace the module WD21X10370. Thank you. Read More...
Bob11 May 23, 2011 for Model Number PDW9280L00SS Why does my dishwasher keep running? Is it the control board?
1 Answer Hello Bob! It is possible that it could be a bad board. Is there anything showing on the control display? Does this happen on every cycle selected? Thanks. Read More...
Sam April 03, 2011 for Model Number pdw8900L Had a power surge after which the d/w would not do anything. Tried reset but no change. Is there a transformer in the d/w?
1 Answer Hello Sam. You will need to test and see if your getting power to the control board. If so, you will need to replace the control assembly. Hope this helps. Read More...