Paul November 11, 2015 for Model Number WE4X821 Could you E-mail me the internal switching positions and location? I took my motor of to check it and my timer came apart and the switching levers fell out, and i don't know where they go, please help me.
1 Answer Hello Paul. Sorry, we do not have that information. You will need to contact the manufacturer. Read More...
Ray October 07, 2013 for Model Number DDE7208MDLWH I have a GE Electric dryer. When I set the dial for a particular cycle the dryer will go on when I push the "ON" button. However it does not turn off. It will stay on until I stop it manually. It dosen't matter what cycle it is set on, it never stops on it's own. I thought it might be the timer. I have had the dryer for a number of years. Can you help me?
1 Answer Hello Ray. If there is power to the timer motor, and the timer does not advance, you will need to replace the timer on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Don March 13, 2012 for Model Number DDE7108V When we select the Automatic, Perm Press & Knit side of Cycle Selector, the dial does not advance nor shuts off automatically - it keeps running. Have cleaned connectors and area but problem still exists. Can u provide a reason or solution? Thank you.
1 Answer Don, You want to check and make sure the exhaust venting and hood is clear, has no kinks, or clogs. Check and see that there are no lint clogs, in the duct under the filter or in/on the blower wheel. You may want to dry a small load on the auto cycle with the vent disconnected from the dryer. The air flow has to be proper or the timer won't advance, in the auto cycles. Good Luck and Thanks Read More...
Frank March 28, 2011 for Model Number DDG7180MBL Where are the thermal fuses and flame sensor located, are they attached to the gas valve?
1 Answer Hello Frank. Here is a link to the parts diagram page to help you on the location of the parts. Hope this helps. http://www.appliancepartspros.com/partsearch/model.aspx?model_id=207396&diagram_id=20947926 Read More...
Frank March 27, 2011 for Model Number DDG7180MBL I have replaced the gas valve and the igniter, is there also a thermostat that can be replaced. The dryer does't heat up and this is all I can think that is left.
1 Answer Hello Frank. You will need to test the thermal fuses WE4X592 and flame sensor WE4X448 and make sure they are good. You can test these with a multi-meter MA-DM1. Hope this helps. Read More...