Chuck August 22, 2011 for Model Number wlsr3000go Washer does not go into high speed spin, just turns very slow.
1 Answer Hi Chuck. The motor brake resister under the top motor cover is burnt out. You will get this also with a new motor. The motor part # is WH20X10093. Thank you. Read More...
Soiled Pants August 14, 2011 for Model Number WBSR3140GWW As above, about 3 months ago, the selection knob quit working. I would grip the back knob and turn to desired cycle. Now when I set the cycle it stays there. I went back to my washer an hour later, still in the same spot. I have been moving the select knob by fingers, just to finish the load. I took apart and have the timer switch out. Should I buy another timer switch or by a new washer?
1 Answer Hello Soiled Pants. Based on the information you provided, it sounds like you will need to replace the timer WH12X10350 and the knob WH01X10310. Hope this helps. Read More...
Ron August 14, 2011 for Model Number WBSR3140GWW The washer does not go into spin mode after any wash cycle. Lid switch is good. Belt is good. Motor board light flashes 7 times. Could it be bad timer board?
1 Answer Hi Ron. You are needing to change the lid switch part # is WH12X10334. Thank you. Read More...
Exbiker June 10, 2011 for Model Number WBSR3140G0WW The ability to push the knob in to turn to different settings doesn't work. If I grip the larger inner timer dial I can change settings. Is this usually the timer or the knob?
1 Answer Hello Exbiker. Usually this problem is due to a bad timer knob WH01X10310. You will need to remove the knob and see if the gear teeth are worn on the knob. Hope this helps. Read More...