Maria November 22, 2013 Hello, The refrigerator light is not working properly. Sometimes it stays on when the door is closed, and some other times, it is off for a few hours or even a day when I open the door, and then it turns back on. What seems to be the problem and how can it be resolved?
1 Answer Hello Maria, This can be a switch failing or the unit is not leveled properly or the doors are mis-aligned so the light switch can open properly when the door closes and the switch is supposed to open the circuit. If you post the model number we can get you the correct part number for the door switch. Read More...
Rita September 21, 2013 for Model Number 596.79249010 I am not able to switch between water & ice dispenser on my Kenmore Bottom Mount fridge door control centre, therefore not allowing me to dispense ice thru the door. The water dispenser still works. All other buttons on the control seem to be functioning okay. Any idea what the problem might be?
1 Answer Rita, With the keypad not working properly the most likely cause of failure would be the overlay which is the keypad for the unit. Read More...
Sulaiman September 02, 2013 for Model Number LFX25960ST There is no power to the ice make and the dispenser does not dispense water or ice.
1 Answer Sulaiman, You will want to pull the upper left hinge cover to check to make sure that there is no loose or broken wires. If this checks ok then the main control board would be the issue. Read More...
Shelly July 27, 2013 for Model Number lfx25950tt The fresh food lights will not come but if you press both door switches they will flicker sometimes even come on but when you close door they will not come back on when you open door.
1 Answer Hello Shelly. The lights are powered by the main board EBR34917110 on the back of the unit. If the relay is not working, you will need to replace the board on the unit. Also, check all connections and make sure they are good on the unit. Read More...
Branden June 12, 2013 for Model Number LG LFC25760SB I have an LG french door bottom mount unit. My fresh food lights won't light up but my freezer light works just fine. The beeper sounds still let you know the door is open. You can see the lights flicker but they won't come on. What part do you suggest I need?
1 Answer Hello Branden, This has been a long running issue with this design unit. The main control board (AP4439541) on the back of the unit will have to be replaced. Read More...
Pam May 08, 2013 Our LG french door refrigerator stopped cooling though the freezer still works. If I unplug it and plug it back in it will run for a few seconds. The temperature controls will work temporarily when I do this and then the freezer control stays lit on the number six and seven and the refrigerator control does not light at all. The up and down arrows on the temp controls do not respond to touch. Is this an electronic problem?
1 Answer Pam, Based on the information provided it sounds like the main control board may be faulty causing the error. Read More...
Bob March 23, 2013 for Model Number LG Refrigerator, model LFX2591ST Our LG Refrigerator has french doors on the refrigerator section and a freezer section in the bottom. We are having problems adjusting the temperature in the meats and vegtable drawers. The refrigerator section is too cold and causes the fruits and meats to freeze. We have repeatedly attempted to change the temperature of the refrigeration section via the electonic controlson the front door. It remains too cold. What do you recommend? The unit is about three years old.
1 Answer Bob, You will want to check the damper that is located behind the multi-duct assembly MCZ54121501 in the refrigerator compartment. It sounds as if the duct is not closing when the temperature is where is should be. This would allow air migration back into the refrigerator compartment from the freezer and cause the crispers to freeze. Read More...
Tom S March 18, 2013 for Model Number LFX25960ST Sometimes the dispenser lights flash and there is a clicking noise. It lasts for quite some time and them goes away. I can get the flashing to stop by holding down the lock button. Then the lights just stay on. I understand that is an issue with the control board, but I am not sure if that would be the main control board or something else. I thought I saw something about capacitors going bad (looking swollen). Please confirm what I should replace to fix the issue. Also I am unable to clear the months remaining on my filter. It stays at 2 (months). I am not sure if this is a different problem. Thank you for you help.
1 Answer Tom, Based on the description it sounds like the issue would be in the dispenser control board 6871JB1432A. Read More...
George March 01, 2013 for Model Number LFX25960TT Currently my water & ice dispenser are not working. I have changed out the door switches and that has not helped. Can you please provide me with any suggestions? The Mother Board does light up.
1 Answer George, You will want to check the wiring at the top of the door first to see if there is a loose or broken connection. You will also want to check the main PCB to make sure that it is receiving signal back from the dispenser to allow the ice and water to work. The voltage should be 12 vdc and if you are not getting this then you will want to also check the dispenser control to make sure that you are getting 12vdc there. Read More...
Doug February 26, 2012 for Model Number 795.77572600 how difficult is this to install? my frig has error code -Er if. I can only assume this is the remedy[I can't change anything on control panel and the icemaker won't fill now. I believe this occurred from a dip or sag in my electricity months ago. the error code now stays on all the time. any other suggestion? thanks.
1 Answer Hello Doug. Based on the error code you provided, it sounds like the fan motor 5209JA1044A is bad and will need to be replaced in the unit. Hope this helps. Read More...