Gary June 01, 2018 for Model Number LG dlg5988s If I replace the rollers only without the axles what lube do I use on the axle?
1 Answer Hello Gary, You should use a dry paper towel to clean the shafts and install the rollers dry. They are impregnated with a dry lubricant so when they wear, they self-lubricate. Never use a wet lubricant on the rollers since lint will stick to it and be pulled into the bushing and they will fail prematurely. If you must use something, use cornstarch or baby powder and do not use too much. Rotate them before reassembly since they can bind with too much. Read More...
Harry April 03, 2018 for Model Number LG DLE5977W Does this Drum Support Roller Assembly AP5688895 include all rollers required or do I need to order four? Thanks
1 Answer Hello Harry, I'm sorry but 4581EL2002L is one drum roller only. If four are needed, you will need to order four. Read More...
Steve J March 25, 2018 for Model Number DLE0442W Can you please tell me if this part (AP5669956) will work for the DLE0442W? I did the cross check, and states that the part would not fit, although it is listed from the part diagram for this model. I only need the rollers, not the entire assembly.
Jack March 19, 2018 for Model Number dlg3788w I need drum support roller assemble is that part 4581el2002c.
1 Answer Hello Jack. You will need to order 4581EL2002L for the roller needed. As soon as it is in stock, we will ship it out to you. Thank you. Read More...
Rudy March 16, 2018 Are all the Drum support rollers the Same? or should I order 2- # K250 & 2- #251? Where can I order from?
1 Answer Rudy, If you need the rollers you would only need to get 4 of part number 4581EL3001E. Read More...
Renee March 13, 2018 for Model Number DLE2301R My dryer sounds the the drum is slipping. It was running fine , then it started making a noise.
1 Answer Renee, You will want to check the rollers and the idler pulley to make sure that they are good and visually inspect the belt to make sure that it is not damaged. Read More...
Denise A January 29, 2018 for Model Number LG TRomm DLE 3777W I bought drum rollers believing that I could remove the axles from the old parts. Is that possible? If not, why do places sell drum rollers without them and not say those parts May/will be needed? Secondly, in disassembly, I found lint inside the dryer hull. I noted that the rubber seal on the back of where the lint trap is seems rotted. Is this replaceable, or should I have other concerns. I don't want to put it back together again and waste more time. Thanks!
1 Answer Denise, The seal on the lint filter will not be replaceable and they do not put it on them anymore. As for the roller it will come off the shaft and will just need to remove the triangle on the front of the axle then slide the roller off. Read More...
Joseph December 17, 2017 for Model Number LG dle7177rm My question is if once you replace the drum belt is it necessary to run the dryer empty in order to stretch the belt?
1 Answer Hello Joseph, It is not necessary to run the dryer until you need to dry clothes. The dryer belt should not stretch since it has strands in it to prevent stretching. Read More...
Tom November 07, 2017 for Model Number DLG5988W My roller(s) have gone bad. Do I need the Roller assembly + shaft or just the roller assembly? Thanks
Loren September 28, 2017 for Model Number DLEX2501W 2nd question is should I just replace the belt and pulley while I have it disassembled?
1 Answer Hello Loren. If you see any damage on he belt or the pulley then you would need to replace them. Otherwise, they should be fine in the unit. Thanks. Read More...