Ross M January 21, 2017 for Model Number WM2020CW I've got a front loader washer I put a rug into. It threw an UE code and now won't spin with anything in it. It will work empty. I've got the stator out of it and I'm reading 9.0 ohms across the terminals. Thought it was the stator but leaning more towards the control board.
1 Answer Ross, You will want to check to make sure that the spider did not break on the back of the tub. Also check the wiring of the unit to make sure that nothing disconnected. If this checks ok then the control or door lock would be the likely issues. Read More...
Steve August 30, 2015 for Model Number WM2010CW Hello, when I start a cycle the tub acts like it wants to spin but wont. Then the "LE" code flashes. When it does spin it sounds very loud. Any help would be appreciated!
1 Answer Steve, The LE error code is a hall sensor error in which the control board is not sensing proper rotation of the tub. You will want to check the hall/RPS sensor. Also check the bearings on the unit as it sounds like the bearings may be bad. Read More...
Ken June 03, 2014 for Model Number WM2010CW Is there a way to test the stator? My machine makes a sound like the tub belt is slipping on a dryer tub. It kind of just sputters and then stops turning. I removed the housing and stator and both look just fine. Could this be the sensor that hooks to the stator PN# 451?
1 Answer Hello Ken, Being a three phase motor 4417EA1002J, each winding should read very close to the other two, (Resistance of terminal: 1-2/2-3/1-3 : About 5 ?-15 ?). If one is open or shows no resistance to ground, the motor has failed. Check also for cracked or broken magnets in the rotor 4413ER1002F.If all read good, the RPS 6501KW2001A is the next suspect. Read More...