Pete November 07, 2018 for Model Number RFG237ACRS 7 year old fridge has been intermittently not cooling. Compressor will fail to turn on maybe once every couple of weeks for an unknown length of time and I would notice things in the freezer starting to thaw but the next day everything would be fine. Lately it is happening more often and lasting longer - to the point where everything thaws out. I am getting one blink on the diagnostic LED. Everything I have read leads me to believe the inverter board needs to be replaced, but I'm wondering if it could be anything else?
1 Answer Pete, one blink on the inverter board represents a starting failure on the compressor. I would recommend replacing the inverter board, part number is DA92-00215C Read More...
Patrick October 28, 2018 for Model Number RF263BEAESR My Samsung French door with water dispenser runs intermittently and stops All the white lights in the fridge start to blink and I have to unplug it eventually, Sometimes it re-starts after a whirring sound from the back and the sound of water dripping from the back it may run for a day at the most before the blinking lights start again.
1 Answer Patrick, Based on this issue it sounds likely that the main control board of the unit would be causing the unit to act in this manner. Read More...
Parker October 04, 2018 for Model Number Samsung RF268ABRS Hello, I have the aforementioned Samsung French door. Freezer and refrigerator not cooling or making ice. No error codes on front display. If I unplug and let sit for minute, restart appears two flashes on inverter bd led then goes off. Sound like something is running internally but do not hear compressor running. Funny thing is, when I check open lands on control pub for dc voltage, inverter bd led turns on solid and it sounds like compressor starts. Thanks in advance, Parker
1 Answer Parker, Based on the information this would be a faulty inverter board on the unit. Read More...
Bsp September 26, 2018 for Model Number RF28K9380SR/AA My refrigerator stopped cooling after 2 years and 10 days. The first tech said that the relay switch needs to be replaced. He could hear the compressor noise for about 5 sec and then no noise. The second tech from same company said that the inverter board needs to be replaced. What can be the reasons for a new refrigerator to stop working? The display shows 84 on left and C on the right where normally temperatures are displayed.
1 Answer BSP, The 84 C error code is a compressor motor stall error. Check the compressor wire connections and the soldering of the components on the inverter. This issue sounds likely that it would be an inverter issue. Read More...
Rene September 20, 2018 for Model Number rs265tdrs I just bought an inverter to fix my rs265tdrs (initially blinking once) After I installed the new one DA41-00585A now LED blinks 4 times. Please help. I am getting 120 VAC going to inverter and DC voltage on compressor control from main board. But no AC voltage on the three wires going to the compressor from inverter. Thanks
1 Answer Rene, if the inverter is blinking 4 times, it means the motor is locked and the compressor will need to be replaced. Read More...
Glenn Kleiner August 28, 2018 for Model Number RF28HFEDBSR/AA-0002 My fridge energy saver indicator On the touchpad has been blinking on and off for the last 12 hours along with the chiming. I looked at the circuitboard in the back and there was no red LED on until the motor underneath kicked on. The LED stayed constant throughout. Any ideas to the cause of the energy saver issue?
1 Answer Glenn, it sounds like you have a shorted or stuck key pad on the control panel, you will need part number DA97-13809F Read More...
Jeff August 21, 2018 I have a samsung rs265tdbp it is intermittently working. I have read your comments regarding the DA41-00614F Assembly PCB Sub Inverter. How hot should the heat sink on this board get. Mine is getting to the point that you can't touch it. it has also slightly scorched the plastic on the wall it is mounted on. I have also checked the fuse and it is good. Is it heating up so much that it shuts down? Thanks
1 Answer Jeff, Unfortunately we do not have information on how hot the heat sink will get but if it is getting hot enough to scorch plastic then this would be too hot. Read More...
Jerry July 29, 2018 for Model Number RFG297AARS/XAA HI, I SAW A VIDEO THAT THE REASON MY FRIDGE IS NOT COOLING IS BECAUSE MY PCB INVERTER HAVE A ERROR CODE, OF COURSE DEPENDING ON THE NUMBER OF BLINKS ON THE RED LIGHT, BUT FOUND OUT THE RED LIGHT IS OFF, NO SOLID LIGHT, NO BLINKING, NOTHING. SO IS THE PCB GONE BAD? THANKS FOR YOUR RESPONSE
1 Answer Jerry, for normal operation of the inverter board, it should have a solid red light, if you are not getting voltage, check back at the main control to see if it is sending voltage to the inverter Read More...
William Costa July 16, 2018 for Model Number RF22K9381SR/AA I have a 84 C error code. My PCB inverter board blinks 4 times. Will replacing the board fix the issue or is this a bigger problem ?
1 Answer William, the light on the invertor that blinks 4 times means that the rotor is locked up in the compressor and the compressor would need to be replaced Part number is NC1MV90ALP/ASH Read More...
Renee July 15, 2018 for Model Number Samsung refrigeratormodel #RF25HMEDBBC Our Samsung refrigerator is not cooling. The freezer is working fine. The compressor and fan are working. 8 months ago the same thing happened and the repair man replaced the assembly cover and evaporator and it worked fine until a month ago. We had a repair man come out and said it was the main upper control board so we ordered it from you guys and my husband put it in. The refrigerator is still not cooling and on the inverter board(DA92-00483B) the red light is staying on. Does the inverter board need replaced?
1 Answer Renee, You will want to pull the rear cover of the refrigerator out and check the frost pattern on the evaporator coils. The unit having a defrost issue would be the most likely cause for this issue. Read More...