Rob August 01, 2017 for Model Number RB1944SL I plug in my refrigerator set the desired temperature it cools down 5 hours 10 hours later the control panel is blinking the refrigerator is warming up and freezer unplug it reboot it the compressor comes on it goes back down 5 hours later 10 hours later his blinking again what do I need
1 Answer Rob, This issue will most likely be caused by the main control board being faulty. Read More...
Willis September 09, 2016 for Model Number RB2044SL Refrig temp display on outside of door indicating accurate temp of freezer 34 deg ff dept 56 deg. Upon unplugging and re-plugging unit starts and get back down to normal temps freezer 0 - 5 deg ff to 34 -36 deg. This is necessary to do every 4 hrs approximately. It will not restart after cycling once. The control board has been replaced. Not sure where to check next. Local repairmen thought the control board was faulty, so it was replaced and still does same thing.
1 Answer Willis, You will want to test the sensors in the unit to see if they are faulty. The resistance for the thermistor should be 5K at room temperature. Read More...
Gary Casarez September 04, 2016 for Model Number Samsung RB1855sl How can I check to see if my main control board needs to be replaced need to check defrost timer thermostat overload relay my refrigerator stop work completely and I like to check them to see which on might need to be replaced so I don't replace something that is still good
1 Answer Gary, You will want to check to see if the compressor is running on your unit. If it is hot but not running then test for 120 vac to the overload and relay. If there is 120 vac then the likely cause would be a faulty overload and relay assembly. Read More...
Thomas F June 16, 2016 for Model Number RB2044SL/XAA Freezer is -2 Frefrigerator + 64. Ref compartment light not come on but the alarm is, both fan motor is good but the freezer one is not running the one in the back is. What could be the problem.
1 Answer Thomas, With the refrigerator being at 64 degrees then you would want to check the evaporator in the refrigerator compartment to make sure that it is not ice over. If it is then this would be a defrost system issue. You would want to check the defrost sensor for resistance and heater to make sure that they have continuity. If these check ok then replace the control board and if they check bad then replace the part that is faulty. Read More...
Naman September 30, 2015 My samsung fridge RB2155BB has the front lights blinking and the fridge and freezer temps are near room temp. After reboot (unplug & plug the power) the fridge and the freezer go to set temperatures, but after 24 hrs the cycle repeats it self. Any idea what could be the issue. Starter solenoid or main board or defrost sensor??? thanks
1 Answer Naman, With the unit not cooling at all and the lights blinking, if the door alarm is also going off then the issue would most likely be a door switch issue. if the door alarm is not going off then the main control board would most likely be the issue. Read More...
Guy D August 23, 2015 for Model Number RF266ABRS My refrigerator section fan does not get power. I am getting 11 volts to the freezer fan at connector CN75 pin 2, at pin 3, I would expect the same (refrigerator fan). The refrigerator fan is not connected as this also needs to be replaced. Is this just going to be a fan replacement or is the control board shot? Where is the control board identifier?
1 Answer Guy, If the refrigerator fan is not showing power at the control board then the control board would need to be replaced. The part number for the control board is DA41-00413G. Read More...
Glenn June 23, 2015 for Model Number Samsung RB2155SH I have a Samsung RB2155SH Fridge. I can no longer change the temperature with the external controls for the Fridge. The temp control for the freezer works fine. But the fridge I can't control. Both the fridge and the freezer still cool though. Is this a control board issue?
1 Answer Hello Glenn. The part needed DA41-00225A has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
Linda June 20, 2015 for Model Number samsung rb195zasb Hi there, I have a Samsung bottom mount fridge rb195zasb it freezes, it cools, it lights up but not all at the same time. The unit runs for a few hours, then either the top or bottom stops working. Touch pad on the front does keep program reverts back to -88 88 any ideas.
1 Answer Linda, With the unit not being constant as far as which section is working and which section shuts down, this issue will most likely be caused by a faulty main control board. The part number for the control board on your unit is DA41-00293A. Read More...
Eugene June 05, 2015 for Model Number RS267LASH/XAA-0000 I have a samsung refrigerator and the refrigerator part freezes and does not defrost, but the freezer works fine. I defrosted it manually and checked out the heater and the limit switch and all checked out fine ran the unit again and it froze the coils again.
1 Answer Hello Eugene. You will need to test the defrost parts on the evap coils and if they are good, then you will need to replace the main board on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Tom C May 20, 2015 for Model Number RB2155SW The refrigerator indicated the correct temperatures, but wasn't. The temperatures were actually higher. Unplugged, rebooted, replugged and the readout showed the real temp, the unit started and cooled back to the setpoint and shut down. The readout stayed at the correct temperature, but the unit warmed up again. A reboot repeated the same process. Purchased and installed a new control board. Plugged the unit in and the original problem repeated itself. What else could possibly cause the readout to lock up? Is the replacement board also faulty? Do you warrant the boards? If so, will you send a replacement for exchange?
1 Answer Hello Tom. It sounds like the front board DA97-00352X is bad on the unit. This part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...